Hello,
Am Montag, den 26. Oktober schrieb M G Berberich:
> Canon datasheets say, the Canon LiDE 210 has 2.5 W max power in work,
> 1.4 W in standby and 11 mW in suspend.
>
> Is there any way to determine (via sane) if it is in standby or
> suspend? Can it be switched between standy and suspend?
The Canon LiDE 210 uses about 400mA during work, 240mA in standby and
40mA in “sleep-mode”.
After beeing pluged in it is in 40mA-mode, after beeing used it seems
to never return to this mode but stays in 240mA-mode.
USB autosuspend reduces its power-consumption to 0 and seems not to
influence usability. It wakes up on usage and returns to 0 after use.
(As far as I can tell from a short test.)
But it never reaches this state on a standard sane-install because in
sane-backends/tools/udev/libsane.rules
both the ATTR{power/control}="auto" is missing and a special rule
disables USB autosuspend for all USB-scanners.
# The following rule will disable USB autosuspend for the device
#ENV{libsane_matched}=="yes", RUN+="/bin/sh -c 'if test -e
/sys/$env{DEVPATH}/power/control; then echo on >
/sys/$env{DEVPATH}/power/control; elif test -e /sys/$env{DEVPATH}/power/level;
then echo on > /sys/$env{DEVPATH}/power/level; fi'"
Maybe this behavior should be changed.
MfG
bmg
--
„Des is völlig wurscht, was heut beschlos- | M G Berberich
sen wird: I bin sowieso dagegn!“ | [email protected]
(SPD-Stadtrat Kurt Schindler; Regensburg) |
--
sane-devel mailing list: [email protected]
http://lists.alioth.debian.org/cgi-bin/mailman/listinfo/sane-devel
Unsubscribe: Send mail with subject "unsubscribe your_password"
to [email protected]
