Dear all,
I have an atheros 9825 wireless card (on a compaq CQ60-615DX) which is
detected, but somehow fails to connect to -- or rather immediately disconnects
immediately from -- the network when the password is given. I am running it
using linux 5.5 livedvd, but the same device connects successfully under
Windows7.
It seems this issue was discussed sometime before, but I do not seem to find
it. Any help appreciated. Below are details from wpa_supplicant.log and dmesg
that I guess are helpful.
William.
$ uname -a
Linux slinux 2.6.18-194.3.1.el5 #1 SMP Fri May 7 01:52:57 EDT 2010 i686 i686
i386 GNU/Linux
$ cat /var/log/wpa_supplicant.log
(wext) Device wlan0 kernel driver name: ath9k.
Device wlan0 kernel driver name: ath9k.
Trying to associate with 00:18:e7:01:64:af (SSID='doit1wlan' freq=2437 MHz)
Associated with 00:18:e7:01:64:af
WPA: Key negotiation completed with 00:18:e7:01:64:af [PTK=TKIP GTK=TKIP]
CTRL-EVENT-CONNECTED - Connection to 00:18:e7:01:64:af completed (auth) [id=0
id_str=]
CTRL-EVENT-DISCONNECTED - Disconnect event - remove keys
$ dmesg |tail -35
r8169: eth0: link down
ADDRCONF(NETDEV_UP): eth0: link is not ready
ADDRCONF(NETDEV_UP): wlan0: link is not ready
ACPI: PCI interrupt for device 0000:00:1b.0 disabled
PCI: Enabling device 0000:00:1b.0 (0000 -> 0002)
ACPI: PCI Interrupt 0000:00:1b.0[A] -> GSI 22 (level, low) -> IRQ 58
PCI: Setting latency timer of device 0000:00:1b.0 to 64
hfs: unable to find HFS+ superblock
ACPI: PCI interrupt for device 0000:00:1b.0 disabled
PCI: Enabling device 0000:00:1b.0 (0000 -> 0002)
ACPI: PCI Interrupt 0000:00:1b.0[A] -> GSI 22 (level, low) -> IRQ 58
PCI: Setting latency timer of device 0000:00:1b.0 to 64
[drm] Initialized drm 1.0.1 20051102
ACPI: PCI Interrupt 0000:00:02.0[A] -> GSI 16 (level, low) -> IRQ 74
[drm] Initialized i915 1.8.0 20060929 on minor 0
set status page addr 0x03fff000
wlan0: direct probe to AP 00:18:e7:01:64:af (try 1)
wlan0: deauthenticating from 00:18:e7:01:64:af by local choice (reason=3)
wlan0: direct probe to AP 00:18:e7:01:64:af (try 1)
wlan0: direct probe responded
wlan0: authenticate with AP 00:18:e7:01:64:af (try 1)
wlan0: authenticated
wlan0: associate with AP 00:18:e7:01:64:af (try 1)
wlan0: RX AssocResp from 00:18:e7:01:64:af (capab=0x431 status=0 aid=1)
wlan0: associated
ADDRCONF(NETDEV_CHANGE): wlan0: link becomes ready
wlan0: no IPv6 routers present
wlan0: deauthenticating from 00:18:e7:01:64:af by local choice (reason=3)
