Hi everyone. I was curious if anyone could look at the following and tell
me what the problem is. I'm sending 3 consecutive T=1 commands. The first
command always works but any after that do not. For example:
IBM T=1 Card
Command 1: Select File
-> 00 00 07 00 a4 00 00 02 00 07
<- 00 00 10 63 0c 03 e8 00 07 00 00 00 ff ff 11 01 00 90 00 13
Command 2: Write Binary
-> 00 00 07 00 d6 00 00 02 00 00
<- 00 92 00 92
No matter what the first command always work and the second comes back with
00 92 00 92. This could only be an error R block but why ? Is there
something I need to do to close the first command ?
Regards,
Dave
David Corcoran Purdue University
1008 Cherry Lane MUSCLE Smartcard Developers
West Lafayette, IN 47906 http://www.linuxnet.com
765-463-0096 317-514-4797
If you can't make it work - at least make it look good. ~ Bill Gates, M$
***************************************************************
Linux Smart Card Developers - M.U.S.C.L.E.
(Movement for the Use of Smart Cards in a Linux Environment)
http://www.linuxnet.com/smartcard/index.html
***************************************************************