[Elecraft] KBPF3 100-400 kHz Modification

I am considering the Elecraft modification to the KBPF3 for 630m coverage on my K3. Is there any information published on the band pass filter performance before and after the modification? If the KBPF3 modification compromises performance elsewhere in the coverage, I might be better off using

[Elecraft] 10 MHz IF for K3 Transverter Operation?

I've seen a couple of old posts concerning the addition of a 10 MHz IF for use with the K3 (and KXV3 option). Is this upgrade being worked at Elecraft? I operate my K3 using an external 10 MHz frequency reference. The 10 MHz IF capability would allow use of the same external 10 MHz reference as

[Elecraft] 10 MHz Transverter Band IF for K3

A clarification is in order concerning my earlier post. If not already available, I am requesting a K3 firmware revision that adds the selection of a 10 MHz IF for transverter operation (via the XVn IF CONFIG menu selection). In my application this added selection would allow use of the same

[Elecraft] Use of K3 on 600m (and below)

While the K3 is not designed for direct operation at 600m and below (filtering is designed to protect 160m operations from BC band interference) the K3 features that support use of transverters make this rig one of the best for use as an IF. There are separate ports and electronic switching for

[Elecraft] K2 K60XV IF Selection Option Question

I'm using my K2 with a recieve converter for the 600m band, currently interfaced via the receive antenna port. I recently installed the K60XV accessory to my K2 in preparation for use of the K2 as the IF on both transmit and receive on 600m. The problem: I discovered the firmware offers IF band

[Elecraft] Pelican Case for K2

___ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: