I am busy with some ngcgui stuff to cut some small parts on a lathe. The
tools are setup as back tools on the lathe but I need to cut the Id of
the job with the same too as the od. So the lathe set up as a back tool
lathe on Gmoccapy and the OD shows correct but I need to cut the ID in
the
On 24 March 2014 13:23, Marius Liebenberg mar...@mastercut.co.za wrote:
Is there a way to
switch between these two modes with Gcode?
I _think_ you can just use a negative diameter and it works.
--
atp
If you can't fix it, you don't own it.
http://www.ifixit.com/Manifesto
I tried that Andy but is does not work as expected. I will have to write
the routine to explicitly do that.
I was hoping to find a shortcut and not have to write it from scratch.
No problem I like learning new stuff. It's what drives me :)
On 2014-03-24 15:33, andy pugh wrote:
On 24 March
I found a solution. If you just put a (-) in front of the Z figure it
travels the opposite way. You also have to swing the incremental counter
for the no of cuts to add in stead of subtract as well.
On 2014-03-24 15:49, Marius Liebenberg wrote:
I tried that Andy but is does not work as
On Monday 24 March 2014 10:38:50 Marius Liebenberg did opine:
I found a solution. If you just put a (-) in front of the Z figure it
travels the opposite way. You also have to swing the incremental counter
for the no of cuts to add in stead of subtract as well.
The way your OP was worded, I
