Hi,
In the beginning i was using 2 dishes on each side. They are ubiquiti 2x2 dual
polarized dishes and i connected the chains of station in the same way as AP
and i still had issues. After that i thought the problem might be because this
card uses mimo multipath and AP ch0 should talk wi
This is long distance, 5km with 4 dishes on each side. They are all vertical
and all chains have signal range -60 to -65.
I don't have omni antennas. Is there a problem that i am using dishes?
On Wed, Sep 25, 2019 at 5:11 PM +0200, "Ben Greear"
wrote:
Is this short distance o
Hello,
Today i managed to connect the station wds at 80MHz channel. Signal is -56 and
i have very low datarates. I have attached a photo.
When station was ddwrt and AP openwrt the datarates were 866/433. TX won't do
more than VHT-NSS 1 although RX it's not good either because it's a 4 chain
rad
Hi Ben,
When do you think you might be able to make those changes to your
driver?
Thanks,
Klevis.
On 2019-09-20 13:00, Ben Greear wrote:
On 9/20/19 12:55 PM, Vincent Wiemann wrote:
Hi Klevis,
have you tried it with a short distance?
If you did you should better ask Ben Greear directly.
Hi Ben,
When do you think you can port those changes to your firmware?
Thank you for your support.
Klevis.
On Fri, Sep 20, 2019 at 10:01 PM +0200, "Ben Greear"
wrote:
On 9/20/19 12:55 PM, Vincent Wiemann wrote:
> Hi Klevis,
>
> have you tried it wi
Hi Vincent,
I have tried short distance with ddwrt and i get 1733/1733 datarates and about
1Gbps real traffic using iperf. Ubiquiti and MikroTik have 80MHz outdoor radios
and they work good. I don't want to use 160MHz which is very wide and there are
lot of 20MHz channels within that will cr
Hello everyone,
I am trying to setup a custom made outdoor link with Apu2d2 board devices and
QCA9994 cards from compex. After i installed openwrt and ath10k ct driver, kmod
ath10k and board-2.bin the device can run a 80MHz channel in WDS AP. The
problem is that it won't run as station or statio
Do you reckon the same issue is affecting the wpj344?
On Tue, 2016-03-01 at 04:06 +0100, Matthias Schiffer wrote:
> Signed-off-by: Christian Mehlis
>
> Backport of r46282
> ---
> target/linux/ar71xx/files/arch/mips/ath79/mach-wpj531.c | 11 +--
>
> 1 file changed, 5 insertions(+), 6 de
tifd, procd, uci, rpcd, ubox & uhttpd
> * Driver updates
> - ledtrig-netdev: fix possible deadlock
> - bcm47xxpart: fix bcm53xx booting on NAND with badblocks
> - brcmfmac: fix getting/setting TX power, add stations dumping
> and
> support beamforming
>
The ubnt pro and outdoor+ have a different factory TFTP firmware.
Let me know if you need that, however you should be able to recover
with the openwrt one.
Still digging through the commit loggs for trunk, can't see the patch.
Am I missing something?
Cheers,
A
On Mon, 2015-12-14 at 12:54 +0100, St
10 matches
Mail list logo
