Hi, I'm trying to setup two VPN tunnels to the same destination peer from 2 outside interfaces on the PIX. Both the outside interfaces have IP addreses from 2 ISPs. These interfaces terminate on a switch which forwards the packets to a router with 2 ip addresses on the eth port from the 2 ISPs. I'm using a route map on the router to route the traffic based on the source adderess.
When I do a "ping outside www.yahoo.com", it goes out through the 1st ISP and when I do a "ping outside1 www.yahoo.com" it takes the 2nd ISP. At any point in time, only 1 tunnel gets active depending on my routing statement. I have access lists created which binds to the crypto maps applied on these two interfaces. Even after creating a second route with a higher metric, the packets are tyring to take the default path. If I change the default path then the second tunnel gets initiated but the 1st one goes down. Is there anyway for me to get around this? Thanks Allen Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=56489&t=56489 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
