Package: installation-reports Debian-installer-version: Netboot beta 3 (2.6 kernel) 11-Aug-2006 http://ftp.nl.debian.org/debian/dists/testing/main/installer-sparc/beta3/images/sparc64/netboot/2.6/boot.img
uname -a: Linux (none) 2.6.17-2-sparc64 #1 Sat Aug 12 17:17:29 BST 2006 sparc64 unknown Date: Fri Aug 25 22:10:31 EST 2006 Method: Installed by setting up a tftp server on another blade running solaris 9. Created a /tftpboot directory with the above boot.img which was successfully picked up by the b100 blade upon rebooting using "boot net" method. However, it could not pick up the network interfaces (2xSun Cassini 10/100/10000 Ethernet) and the installation cannot proceed any further. Machine: SUN Sun b100 (inside bx1600 chasis) Processor: TI UltraSparc IIe (Hummingbird) Memory: 1Gb Output of lspci and lspci -n: #lspci 00:00.0 Host bridge: Sun Microsystems Computer Corp. Ultra IIe 00:03.0 Non-VGA unclassified device: ALi Corporation M7101 Power Management Controller [PMU] 00:07.0 ISA bridge: ALi Corporation M1533/M1535 PCI to ISA Bridge [Aladdin IV/V/V+] 00:0a.0 Ethernet controller: Sun Microsystems Computer Corp. Cassini 10/100/1000 (rev 20) 00:0b.0 Ethernet controller: Sun Microsystems Computer Corp. Cassini 10/100/1000 (rev 20) 00:0d.0 IDE interface: ALi Corporation M5229 IDE (rev c4) #lspci -n 00:00.0 0600: 108e:a001 00:03.0 0000: 10b9:7101 00:07.0 0601: 10b9:1533 00:0a.0 0200: 108e:abba (rev 20) 00:0b.0 0200: 108e:abba (rev 20) 00:0d.0 0101: 10b9:5229 (rev c4) Base System Installation Checklist: [O] = OK, [E] = Error (please elaborate below), [ ] = didn't try it Initial boot worked: [O] Configure network HW: [E] Comments/Problems: 1. Booted OK from boot.img via "boot net" 2. Installer downloaded and started hardware detection - attempted to install cassini module, but was unsuccessful. The log says: cassini.c:v1.4 (1 July 2004) cassini: Cannot find proper PCI device base address, aborting. cassini: Cannot find proper PCI device base address, aborting. Full dmesg log is: #dmesg PROMLIB: Sun IEEE Boot Prom 'OBP 4.11.5 2003/11/12 10:40' PROMLIB: Root node compatible: Linux version 2.6.17-2-sparc64 (Debian 2.6.17-6) ([EMAIL PROTECTED]) (gcc version 4.1.2 20060729 (prerelease) (Debian 4.1.1-10)) #1 Sat Aug 12 17:17:29 BST 2006 ARCH: SUN4U Ethernet address: 00:03:ba:7a:f2:82 On node 0 totalpages: 130182 DMA zone: 130182 pages, LIFO batch:15 CPU[0]: Caches D[sz(16384):line_sz(32)] I[sz(16384):line_sz(32)] E[sz(524288):line_sz(64)] Built 1 zonelists Kernel command line: PID hash table entries: 4096 (order: 12, 32768 bytes) Console: colour dummy device 80x25 Dentry cache hash table entries: 131072 (order: 7, 1048576 bytes) Inode-cache hash table entries: 65536 (order: 6, 524288 bytes) Memory: 1032064k available (2152k kernel code, 720k data, 144k init) [fffff80000000000,000000005ff42000] Calibrating delay using timer specific routine.. 11.12 BogoMIPS (lpj=22242) Security Framework v1.0.0 initialized SELinux: Disabled at boot. Capability LSM initialized Mount-cache hash table entries: 512 checking if image is initramfs...it isn't (no cpio magic); looks like an initrd Freeing initrd memory: 2781k freed NET: Registered protocol family 16 PCI: Probing for controllers. PCI: Found SABRE, main regs at 000001fe00000000 SABRE: Shared PCI config space at 000001fe01000000 SABRE: DVMA at c0000000 [20000000] PCI quirk: region 0800-083f claimed by ali7101 ACPI PCI quirk: region 0600-061f claimed by ali7101 SMB PCI-IRQ: Routing bus[ 0] slot[ a] to INO[22] PCI-IRQ: Routing bus[ 0] slot[ b] to INO[23] PCI-IRQ: Routing bus[ 0] slot[ d] to INO[20] PCI0(PBMA): Bus running at 33MHz isa0: [serial] [bscbus -> (bscv) (i2c)] [rtc] [power] [flashprom] ebus: No EBus's found. power: Control reg at 000001fe02000800 ... powerd running. usbcore: registered new driver usbfs usbcore: registered new driver hub NET: Registered protocol family 2 IP route cache hash table entries: 8192 (order: 3, 65536 bytes) TCP established hash table entries: 32768 (order: 5, 262144 bytes) TCP bind hash table entries: 16384 (order: 4, 131072 bytes) TCP: Hash tables configured (established 32768 bind 16384) TCP reno registered audit: initializing netlink socket (disabled) audit(1156507047.228:1): initialized VFS: Disk quotas dquot_6.5.1 Dquot-cache hash table entries: 1024 (order 0, 8192 bytes) Initializing Cryptographic API io scheduler noop registered io scheduler anticipatory registered (default) io scheduler deadline registered io scheduler cfq registered Activating ISA DMA hang workarounds. Console: switching to mono PROM 80x34 Real Time Clock Driver v1.12ac [drm] Initialized drm 1.0.1 20051102 ttyS0 at MMIO 0x1fe020003f8 (irq = 7419008) is a 16550A Console: ttyS0 (SU) RAMDISK driver initialized: 16 RAM disks of 16384K size 1024 blocksize loop: loaded (max 8 devices) Uniform Multi-Platform E-IDE driver Revision: 7.00alpha2 ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx usbmon: debugfs is not available usbcore: registered new driver usbhid drivers/usb/input/hid-core.c: v2.6:USB HID core driver mice: PS/2 mouse device common for all mice TCP bic registered NET: Registered protocol family 1 NET: Registered protocol family 17 RAMDISK: Compressed image found at block 0 VFS: Mounted root (ext2 filesystem). cassini.c:v1.4 (1 July 2004) cassini: Cannot find proper PCI device base address, aborting. cassini: Cannot find proper PCI device base address, aborting.
begin:vcard fn:Chi Nguyen n:Nguyen;Chi org:Macquarie University;Meta Access Management System adr:;;;Sydney;NSW;2109;Australia email;internet:[EMAIL PROTECTED] title:Research Coordinator tel;work:+61 2 98509077 tel;fax:+61 2 98506527 url:http://mams.melcoe.mq.edu.au version:2.1 end:vcard
smime.p7s
Description: S/MIME Cryptographic Signature
