Bug#284558: 2.6.8 - DMA not work for DVD drive

2005-02-07 Thread Renat Sabitov 
Horms wrote:
On Fri, Feb 04, 2005 at 05:43:42PM +0300, Renat Sabitov wrote:
Have same problem with 2.6.8 :
>
Could you please be a little more specifc on where your 2.6.8 kernel
came from. And if it was from a kernel-image package from d.o, which
version.
Hi Horms!
It's a package kernel-image-2.6.8-2-686-smp from debian testing. See 
status information about it:

$ dpkg -s kernel-image-2.6.8-2-686-smp
Package: kernel-image-2.6.8-2-686-smp
Status: install ok installed
Priority: optional
Section: base
Installed-Size: 43836
Maintainer: Debian kernel team 
Architecture: i386
Source: kernel-image-2.6.8-i386
Version: 2.6.8-12
Provides: kernel-image, kernel-image-2.6
Depends: initrd-tools (>= 0.1.63), coreutils | fileutils (>= 4.0), 
module-init-tools (>= 0.9.13)
Recommends: irqbalance
Suggests: lilo (>= 19.1) | grub, fdutils, kernel-doc-2.6.8 | 
kernel-source-2.6.8
Conflicts: hotplug (<< 0.0.20040105-1)
Description: Linux kernel image for version 2.6.8 on 
PPro/Celeron/PII/PIII/P4 SMP.

And some more about initrd. I am add in /etc/mkinitrd/modules 2 modules 
- piix and ide_generic, because without this modules my DVD combo drive 
 not recognized during boot. Serial ATA driver starts before 
initialisation of generic IDE and IDE reports that ports are already used.

$ cat /etc/mkinitrd/modules
# /etc/mkinitrd/modules: Kernel modules to load for initrd.
#
# This file should contain the names of kernel modules and their arguments
# (if any) that are needed to mount the root file system, one per line.
# Comments begin with a `#', and everything on the line after them are 
ignored.
#
# You must run mkinitrd(8) to effect this change.
#
# Examples:
#
#  ext2
#  wd io=0x300
piix
ide-generic

$ lspci
:00:00.0 Host bridge: Intel Corp. 82865G/PE/P DRAM 
Controller/Host-Hub Interface (rev 02)
:00:01.0 PCI bridge: Intel Corp. 82865G/PE/P PCI to AGP Controller 
(rev 02)
:00:1d.0 USB Controller: Intel Corp. 82801EB/ER (ICH5/ICH5R) USB 
UHCI #1 (rev 02)
:00:1d.1 USB Controller: Intel Corp. 82801EB/ER (ICH5/ICH5R) USB 
UHCI #2 (rev 02)
:00:1d.2 USB Controller: Intel Corp. 82801EB/ER (ICH5/ICH5R) USB 
UHCI #3 (rev 02)
:00:1d.3 USB Controller: Intel Corp. 82801EB/ER (ICH5/ICH5R) USB 
UHCI #4 (rev 02)
:00:1d.7 USB Controller: Intel Corp. 82801EB/ER (ICH5/ICH5R) USB2 
EHCI Controller (rev 02)
:00:1e.0 PCI bridge: Intel Corp. 82801 PCI Bridge (rev c2)
:00:1f.0 ISA bridge: Intel Corp. 82801EB/ER (ICH5/ICH5R) LPC Bridge 
(rev 02)
:00:1f.2 IDE interface: Intel Corp. 82801EB (ICH5) Serial ATA 150 
Storage Controller (rev 02)
:00:1f.3 SMBus: Intel Corp. 82801EB/ER (ICH5/ICH5R) SMBus Controller 
(rev 02)
:00:1f.5 Multimedia audio controller: Intel Corp. 82801EB/ER 
(ICH5/ICH5R) AC'97 Audio Controller (rev 02)
:01:00.0 VGA compatible controller: nVidia Corporation NV31 [GeForce 
FX 5600XT] (rev a1)
:02:05.0 FireWire (IEEE 1394): Texas Instruments TSB43AB23 
IEEE-1394a-2000 Controller (PHY/Link)
:02:09.0 Ethernet controller: Marvell Technology Group Ltd. Yukon 
Gigabit Ethernet 10/100/1000Base-T Adapter (rev 13)

--
Renat Sabitov   e-mail: [EMAIL PROTECTED]
Stack Soft jid: [EMAIL PROTECTED]
--
To UNSUBSCRIBE, email to [EMAIL PROTECTED]
with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]

Bug#284558: 2.6.8 - DMA not work for DVD drive

2005-02-07 Thread Horms 
On Fri, Feb 04, 2005 at 05:43:42PM +0300, Renat Sabitov wrote:
> Have same problem with 2.6.8 :

Hi Renat,

Could you please be a little more specifc on where your 2.6.8 kernel
came from. And if it was from a kernel-image package from d.o, which
version.

Thanks

-- 
Horms


-- 
To UNSUBSCRIBE, email to [EMAIL PROTECTED]
with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]

Bug#284558: 2.6.8 - DMA not work for DVD drive

2005-02-04 Thread Renat Sabitov 
Have same problem with 2.6.8 :
dmesg:
ly.
Freeing unused kernel memory: 168k freed
Uniform Multi-Platform E-IDE driver Revision: 7.00alpha2
ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
hda: TOSHIBA ODD-DVD SD-R1512, ATAPI CD/DVD-ROM drive
ide1: I/O resource 0x170-0x177 not free.
ide1: ports already in use, skipping probe
Using anticipatory io scheduler
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
vesafb: probe of vesafb0 failed with error -6
NET: Registered protocol family 1
SCSI subsystem initialized
libata version 1.02 loaded.
ata_piix version 1.02
ata_piix: combined mode detected
ACPI: PCI interrupt :00:1f.2[A] -> GSI 18 (level, low) -> IRQ 185
ata: 0x1f0 IDE port busy
PCI: Setting latency timer of device :00:1f.2 to 64
ata1: SATA max UDMA/133 cmd 0x170 ctl 0x376 bmdma 0xF008 irq 15
ata1: dev 0 cfg 49:2f00 82:346b 83:7d01 84:4003 85:3468 86:3c01 87:4003 
88:207f
ata1: dev 0 ATA, max UDMA/133, 234441648 sectors: lba48
ata1: dev 0 configured for UDMA/133
scsi0 : ata_piix
  Vendor: ATA   Model: ST3120026AS   Rev: 3.18
  Type:   Direct-Access  ANSI SCSI revision: 05
usbcore: registered new driver usbfs
usbcore: registered new driver hub
Initializing USB Mass Storage driver...
usbcore: registered new driver usb-storage
USB Mass Storage support registered.
SCSI device sda: 234441648 512-byte hdwr sectors (120034 MB)
SCSI device sda: drive cache: write back
 /dev/scsi/host0/bus0/target0/lun0: p1 p2
Attached scsi disk sda at scsi0, channel 0, id 0, lun 0
device-mapper: 4.1.0-ioctl (2003-12-10) initialised: [EMAIL PROTECTED]
[2342] init_ext3_fs(), err = 0
VFS: Can't find ext3 filesystem on dev dm-0.
VFS: Can't find ext2 filesystem on dev dm-0.
ReiserFS: dm-0: found reiserfs format "3.6" with standard journal
ReiserFS: dm-0: using ordered data mode
ReiserFS: dm-0: journal params: device dm-0, size 8192, journal first 
block 18, max trans len 1024, max batch 900, max commit age 30, max 
trans age 30
ReiserFS: dm-0: checking transaction log (dm-0)
ReiserFS: dm-0: Using r5 hash to sort names
VFS: Can't find ext3 filesystem on dev dm-0.
VFS: Can't find ext2 filesystem on dev dm-0.
ReiserFS: dm-0: found reiserfs format "3.6" with standard journal
ReiserFS: dm-0: using ordered data mode
ReiserFS: dm-0: journal params: device dm-0, size 8192, journal first 
block 18, max trans len 1024, max batch 900, max commit age 30, max 
trans age 30
ReiserFS: dm-0: checking transaction log (dm-0)
ReiserFS: dm-0: Using r5 hash to sort names
hda: ATAPI 48X DVD-ROM CD-R/RW drive, 2048kB Cache
Uniform CD-ROM driver Revision: 3.20
Adding 2097144k swap on /dev/mapper/root_vg-swap_fs.  Priority:-1 extents:1
Real Time Clock Driver v1.12
Capability LSM initialized
ReiserFS: dm-6: found reiserfs format "3.6" with standard journal
ReiserFS: dm-6: using ordered data mode
ReiserFS: dm-6: journal params: device dm-6, size 8192, journal first 
block 18, max trans len 1024, max batch 900, max commit age 30, max 
trans age 30
ReiserFS: dm-6: checking transaction log (dm-6)
ReiserFS: dm-6: Using r5 hash to sort names
ReiserFS: dm-7: found reiserfs format "3.6" with standard journal
ReiserFS: dm-7: using ordered data mode
ReiserFS: dm-7: journal params: device dm-7, size 8192, journal first 
block 18, max trans len 1024, max batch 900, max commit age 30, max 
trans age 30
ReiserFS: dm-7: checking transaction log (dm-7)
ReiserFS: dm-7: Using r5 hash to sort names
ReiserFS: dm-5: found reiserfs format "3.6" with standard journal
ReiserFS: dm-5: using ordered data mode
ReiserFS: dm-5: journal params: device dm-5, size 8192, journal first 
block 18, max trans len 1024, max batch 900, max commit age 30, max 
trans age 30
ReiserFS: dm-5: checking transaction log (dm-5)
ReiserFS: dm-5: Using r5 hash to sort names
ReiserFS: dm-1: found reiserfs format "3.6" with standard journal
ReiserFS: dm-1: using ordered data mode
ReiserFS: dm-1: journal params: device dm-1, size 8192, journal first 
block 18, max trans len 1024, max batch 900, max commit age 30, max 
trans age 30
ReiserFS: dm-1: checking transaction log (dm-1)
ReiserFS: dm-1: Using r5 hash to sort names
ReiserFS: dm-2: found reiserfs format "3.6" with standard journal
ReiserFS: dm-2: using ordered data mode
ReiserFS: dm-2: journal params: device dm-2, size 8192, journal first 
block 18, max trans len 1024, max batch 900, max commit age 30, max 
trans age 30
ReiserFS: dm-2: checking transaction log (dm-2)
ReiserFS: dm-2: Using r5 hash to sort names
ReiserFS: dm-4: found reiserfs format "3.6" with standard journal
ReiserFS: dm-4: using ordered data mode
ReiserFS: dm-4: journal params: device dm-4, size 8192, journal first 
block 18, max trans len 1024, max batch 900, max commit age 30, max 
trans age 30
ReiserFS: dm-4: checking transaction log (dm-4)
ReiserFS: dm-4: Using r5 hash to sort names
ReiserFS: dm-12: found reiserfs format "3.6" with standard journal
ReiserFS: dm-12: using ordered data mode
ReiserFS: dm-12: journal params: device dm-12, si