Olá, Eu tinha duas placas de rede nesse micro. A placa eth0 pifou e fiquei, por um tempo, so com a eth1, funcionando perfeitamente na conexacao discada.
Agora, mudei para o speedy e tive necessidade de compartilhar, novamente, minha rede (ja compartilhava a discada) Comprei uma nova placa PCI e pluguei ela. Mas, ela não é reconhecida. Nos logs, veja abaixo, aparece que ela foi renomeada de eth0 para eth1. Voce saberia se o driver 8139too é, realmente, o indicado para esse hardware? O que eu poderia fazer para configura-lo? Esta havebdo alguma confusao com o udev? Eis as saidas de alguns comandos :~$ sudo modprobe 8139too :~$ lsmod Module Size Used by 8139too 20096 0 mii 4864 1 8139too :~$ sudo ifconfig eth0 up eth0: ERROR while getting interface flags: Dispositivo inexistente No log do dmesg há: [ 2.724640] forcedeth 0000:00:04.0: ifname eth0, PHY OUI 0x732 @ 1, addr 00:0c:6e:b2:40:58 [ 5.098215] udev: renamed network interface eth0 to eth1 [ 25.960017] eth1: no IPv6 routers present No log do kernel há: May 31 09:08:02 maq kernel: [ 2.720643] forcedeth 0000:00:04.0: ifname eth0, PHY OUI 0x732 @ 1, addr 00:0c:6e:b2:40:58 May 31 09:08:02 marcella kernel: [ 2.720730] forcedeth 0000:00:04.0: timirq lnktim desc-v1 May 31 09:08:02 maq kernel: [ 5.094380] udev: renamed network interface eth0 to eth1 May 31 09:08:02 maq kernel: [ 26.040022] eth1: no IPv6 routers present :~$ lspci -vv 01:09.0 Ethernet controller: Realtek Semiconductor Co., Ltd. Device ffff (rev 10) Subsystem: Realtek Semiconductor Co., Ltd. Device 8139 Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- DisINTx- Status: Cap+ 66MHz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR- INTx- Latency: 32 (8000ns min, 16000ns max) Interrupt: pin A routed to IRQ 5 Region 0: I/O ports at c400 [size=256] Region 1: Memory at df000000 (32-bit, non-prefetchable) [size=256] [virtual] Expansion ROM at 30000000 [disabled] [size=64K] Capabilities: <access denied> :~$ lspci -vv | grep -i driver Kernel driver in use: agpgart-nvidia Kernel driver in use: nForce2_smbus Kernel driver in use: ohci_hcd Kernel driver in use: ohci_hcd Kernel driver in use: ehci_hcd Kernel driver in use: forcedeth Kernel driver in use: Intel ICH Kernel driver in use: AMD_IDE Kernel driver in use: serial Kernel driver in use: nvidia :~$ sudo ifconfig -a eth1 Link encap:Ethernet Endereço de HW 00:0c:6e:b2:40:58 inet end.: 192.168.1.2 Bcast:192.168.1.255 Masc:255.255.255.0 endereço inet6: fe80::20c:6eff:feb2:4058/64 Escopo:Link UP BROADCASTRUNNING MULTICAST MTU:1500 Métrica:1 RX packets:30453 errors:0 dropped:0 overruns:0 frame:0 TX packets:27266 errors:0 dropped:0 overruns:0 carrier:0 colisões:0 txqueuelen:1000 RX bytes:31551294 (30.0 MiB) TX bytes:4070306 (3.8 MiB) IRQ:21 Endereço de E/S:0xa000 lo Link encap:Loopback Local inet end.: 127.0.0.1 Masc:255.0.0.0 endereço inet6: ::1/128 Escopo:Máquina UP LOOPBACKRUNNING MTU:16436 Métrica:1 RX packets:3905 errors:0 dropped:0 overruns:0 frame:0 TX packets:3905 errors:0 dropped:0 overruns:0 carrier:0 colisões:0 txqueuelen:0 RX bytes:158626 (154.9 KiB) TX bytes:158626 (154.9 KiB) ppp0 Link encap:Protocolo Ponto-a-Ponto inet end.: 189.xxx.xxx.xxx P-a-P:200.xxx.xxx.xxx Masc:255.255.255.255 UP POINTOPOINT RUNNING NOARP MULTICAST MTU:1492 Métrica:1 RX packets:10773 errors:0 dropped:0 overruns:0 frame:0 TX packets:10632 errors:0 dropped:0 overruns:0 carrier:0 colisões:0 txqueuelen:3 RX bytes:9575731 (9.1 MiB) TX bytes:1873021 (1.7 MiB) wlan0 Link encap:Ethernet Endereço de HW 00:13:46:6d:cf:b1 inet end.: 10.0.0.1 Bcast:10.255.255.255 Masc:255.0.0.0 endereço inet6: fe80::213:46ff:fe6d:cfb1/64 Escopo:Link UP BROADCASTMULTICAST MTU:1500 Métrica:1 RX packets:0 errors:0 dropped:0 overruns:0 frame:0 TX packets:80 errors:0 dropped:0 overruns:0 carrier:0 colisões:0 txqueuelen:1000 RX bytes:0 (0.0 B) TX bytes:14850 (14.5 KiB) wmaster0 Link encap:Não Especificado Endereço de HW 00-13-46-6D-CF-B1-65-74-00-00-00-00-00-00-00-00 UP BROADCASTRUNNING MULTICAST MTU:1500 Métrica:1 RX packets:0 errors:0 dropped:0 overruns:0 frame:0 TX packets:0 errors:0 dropped:0 overruns:0 carrier:0 colisões:0 txqueuelen:1000 RX bytes:0 (0.0 B) TX bytes:0 (0.0 B) :~$ cat /etc/network/interfaces # This file describes the network interfaces available on your system # and how to activate them. For more information, see interfaces(5). # The loopback network interface auto lo iface lo inet loopback # The primary network interface allow-hotplug eth1 iface ppp0 inet ppp provider ppp0 auto ppp0 #iface eth0 inet static #address 192.168.0.1 #netmask 255.255.255.0 #gateway 192.168.0.1 #auto eth0 iface eth1 inet static address 192.168.1.2 netmask 255.255.255.0 gateway 192.168.1.1 #auto eth1 auto dsl-provider iface dsl-provider inet ppp pre-up /sbin/ifconfig eth1 up # line maintained by pppoeconf provider dsl-provider -- To UNSUBSCRIBE, email to debian-user-portuguese-requ...@lists.debian.org with a subject of "unsubscribe". Trouble? Contact listmas...@lists.debian.org