Re: [drakelist] AC-4 measured voltages
Garey Barrell [EMAIL PROTECTED] made an utterance to the drakelist gang -- Al - Sounds good for an unloaded supply. 73, Garey - K4OAH Atlanta Drake B C-Line Service CDs http://www.k4oah.com n7ioh wrote: n7ioh [EMAIL PROTECTED] made an utterance to the drakelist gang -- Hi all, I just installed my 120-240 VAC switch in my AC-4 and replaced R3 with a 100 ohm 10 watt resistor (was burnt). I wanted to be sure I did not have any problems so I checked the voltages to be sure. I think all is OK but thought it wiser to ask those of you with more experience then me if all is well. I just finished checking the voltages as described by Mark Gilger WB0IQK in his AC-4 Trouble Shooting article. I did the test as he described but was wondering if my voltages are close enough or typical of a no load voltage readings at the AC-4 plug. My input voltage is 120VAC, the +650VDC reading is 715VDC, the +250VDC reading is 292VDC, my bias adjusted fine and my filament voltage was 13.86VAC. Thanks, Al, n7ioh -- Submissions:drakelist@www.zerobeat.net Unsubscribe:[EMAIL PROTECTED] - unsubscribe drakelist in body Hopelessly Lost:[EMAIL PROTECTED] - help in body of message Zerobeat Web Page: www.zerobeat.net - sponsored by www.tlchost.net --
Re: [drakelist] AC-4 measured voltages
n7ioh [EMAIL PROTECTED] made an utterance to the drakelist gang -- Thanks guys for verifying the voltages are within the acceptable range. Al, n7ioh -- Submissions:drakelist@www.zerobeat.net Unsubscribe:[EMAIL PROTECTED] - unsubscribe drakelist in body Hopelessly Lost:[EMAIL PROTECTED] - help in body of message Zerobeat Web Page: www.zerobeat.net - sponsored by www.tlchost.net --
[drakelist] AC-4 measured voltages
n7ioh [EMAIL PROTECTED] made an utterance to the drakelist gang -- Hi all, I just installed my 120-240 VAC switch in my AC-4 and replaced R3 with a 100 ohm 10 watt resistor (was burnt). I wanted to be sure I did not have any problems so I checked the voltages to be sure. I think all is OK but thought it wiser to ask those of you with more experience then me if all is well. I just finished checking the voltages as described by Mark Gilger WB0IQK in his AC-4 Trouble Shooting article. I did the test as he described but was wondering if my voltages are close enough or typical of a no load voltage readings at the AC-4 plug. My input voltage is 120VAC, the +650VDC reading is 715VDC, the +250VDC reading is 292VDC, my bias adjusted fine and my filament voltage was 13.86VAC. Thanks, Al, n7ioh -- Submissions:drakelist@www.zerobeat.net Unsubscribe:[EMAIL PROTECTED] - unsubscribe drakelist in body Hopelessly Lost:[EMAIL PROTECTED] - help in body of message Zerobeat Web Page: www.zerobeat.net - sponsored by www.tlchost.net --