K3 beta firmware rev. 2.23 is now available. (Details appear below.)
Several K3 owners successfully tested the ESSB feature (Extended Single
Sideband).
For instructions on how to load beta firmware, please see:
http://www.elecraft.com/K3/k3_software.htm
73,
Wayne
N6KR
* * *
MCU 2.23, 7-31-08
* LSB/USB TRANSMIT EQUALIZATION (experimental): Improved gain balance
between LSB and USB. A 1 to 3 dB difference between the two had been
reported with the 2.7 kHz (5-pole) filter. The passband should also be
slightly flatter.
* ESSB (EXTENDED SINGLE SIDEBAND) ADDED: Allows the K3 to transmit in
SSB modes at a bandwidth of up to about 4 kHz. Requires a 6 kHz crystal
filter on the RF board. Note: ESSB receive is obtained just by
adjusting the WIDTH control.
To enable ESSB transmit:
(1) Make sure the 6 kHz filter is configured correctly for AM transmit;
switch to AM mode, then specify this filter using CONFIG:FLTX AM. (A
future firmware release should allow use of the FM filter for SSB as
well, pending lab tests.)
(2) Locate CONFIG:TX ESSB. Select the desired extended bandwidth for
SSB transmit (3.0 to 4.0 kHz) using VFO A. Then tap ‘1’ on the keypad
to turn ESSB on/off. When on, the “+” icon in the mode area will turn
on. (If you turn ESSB on/off frequently, you might want to assign the
TX ESSB menu entry to a programmable function switch.)
---
http://www.elecraft.com
_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com