Same story here as Andy...
I completed the first resistance checks on my kx1 over the weekend. My
readings (and confusion) are nearly exactly the same as Andy except my
pin 5 resistance is higher at about 33k.
I had taken a lot of care in putting this together as I haven't built a
kit in many years but I rechecked placements, values, and solder joints
just to be sure. I stared through a magnifying glass between making FD
contacts and then stared some more. I resoldered some perfectly good
looking solder joints figuring something must be bad.
Then. after looking back through past postings, I concluded that an
infinite reading is >10k and I would press on, albeit somewhat
nervously. The readings for pins 1, 3, 4, 8, 19, and 20 seemed to be
the important ones and other than that I was looking for shorts.
Then I realized I had completely disregarded the need for a power supply
so I'm on hold until my CUP-36 power supply arrives. Well, I'm winding
toroids, finishing up the tuner and 30/80 kits which I had used as
warmup, and I will put together my NOCAL dummy load.
Did we go wrong someplace or is what we're seeing indeed OK?
Paul KD2MX
___
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
