I would consider that figure acceptable.
With my K3 the isolation between ANT1 and ANT2 is 42dB worst case,
56dB Max.
Moving the single wires around made no difference. I suspect that
the level of isolation is determined by the ATU PCB layout.
Given the size of that board I think that the isolation obtained
is reasonable.
73
Stewart G3RXQ
On Sat, 3 Jan 2009 13:43:21 +0100, Koppendorfer Klaus wrote:
yes isolation between ant1 and ant2 is very bad...
if I have time I try to change the silgle wires from the rs323
ports to the atu-board to koax wires, maybe this will help a
little
73
OE6KYG
KX1 244
K2 1331
K3 115
-Ursprüngliche Nachricht-
Von: elecraft-boun...@mailman.qth.net [mailto:elecraft-
boun...@mailman.qth.net] Im Auftrag von Dick Roth, KA1OZ
Gesendet: Samstag, 03. Jänner 2009 06:14
An: Elecraft Reflector
Betreff: [Elecraft] Isolation between Ant 1 and 2??
Hello and Happy New Year!!
Was doing some testing and discovered Ant 1 signal on Ant 2.
Ant 1 is
my GAP Titan-DX and Ant 2 is a 100W dummy load.
I was just reading the mail on 75 meters and switched to Ant 2
to test
power. When key was off, I heard part of the QSO that was
going on.
While on my dummy load, I was receiving a station S3, which on
Ant 1 was
20 over S9.
Has anyone else seen this crosstalk? If so, what is considered
acceptable?
--
73,
Dick ka1oz
Middleborough, MA
Radio: Elecraft K3/100(Kit) SN 859
Antenna: Titan-DX
___
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
___
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
___
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com