John,
Yes, 1 megohm of resistance to ground for the negative side of Ctrl Bd C13
is a problem, and yes it should be connected to ground. If you have damaged
the through-plated hole during your removal techniques, you should connect
the lead to ground somewhere on the back of the Control Board - adding a
wire to the center leg of the 8 volt regulator would be a good way to do
it - because soldering the capacitor on the component side of the board
would be most difficult - that capacitor will be responding to lower
frequency noise rather than HF, so a moderate length added wire should work
just fine.
73,
Don W3FPR
> -Original Message-
> ...
> Now, I have a question (of course).
> My first resolder job was C13 on Control Board was, naturally, the
> worst. On replacing the cap, I note that the pad is damaged on the
> negative lead. I soldered over to an undamaged part (I hope
> successfully).
>
> My question: is the negative lead supposed to be directly to ground?
> (perhaps soldered on the top of the board) I get about a meg of
> resistance between the lead and ground.
> Is this a problem?
> ...
>
___
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
