Michael,
Yes, I had the mike plugged in, so that's a possibility. However, I
tried reducing the power from 10 watts down to 2 watts or so and it had no
affect (I don't have a KPA100). I also changed from my antenna to a dummy load,
which also had no affect on the problem. But there could be some interaction
problem with the mike PTT. The mike cable shield is connected to pin 8 on the
connector, but the front panel chassis mike connector is not grounded. When
this happens again, I'll remove the mike and see if that cures the problem.
Thank and 73.
Bob
W1SRB
-Original Message-
From: [EMAIL PROTECTED]
[mailto:[EMAIL PROTECTED] Behalf Of Masleid, Michael
A.
Sent: Tuesday, May 16, 2006 11:25 AM
To: elecraft@mailman.qth.net
Subject: RE: [Elecraft] K2 intermittent CW fault - help!
Bob, is the Mic plugged in when this happens? /DOT-PTT is wired to the Mic
input, and perhaps picks up
RF if the shield ground on J2 Mic isn't working.
Michael AB9GV
--Hi All,
-- I have an intermittent problem with CW on my K2 (ser 5309).
___
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
___
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
