Joao,
Before spending the money on a new SCSI card, go to the SANE page and try
their drivers. They list your scanner and the controller it comes with as
supported.. Their site is at http://www.mostang.com/sane/
-Original Message-
From: Joao C Agostini [SMTP:[EMAIL PROTECTED]]
Sent: Monday, August 09, 1999 10:19 PM
To: [EMAIL PROTECTED]
Subject: Re: [newbie] How do I install my scanner Umax S-6E?
Hello
Thank you very much for the information and for the attention. It is
a
sad news, but I will take your advice because, I find, this will be the
only form of doing my scanner to work. But, even so, I would like
something to know on which module for a generic board scsi, do you know?
Thank you again.
Steve Philp ha scritto:
Joao C Agostini wrote:
Hello
Does by chance anybody have a scanner of the mark Umax S-6E? I
saw in
the sane that there is the drive for him, but when I made the
installation of Mandrake it didn't consist a scsi board for him. I
wrote
for to Umax so that they informed me which the type of the scsi board
that they used for S-6E, but until today I didn't obtain answer. Did I
Read in the documents of the sane that the kernel should include a
module (?) of generic scsi, what module is this? How do I do so that
it
is carried by the kernel or so that it is included in him? What should
read to enable my scanner? At once thank you very much.
The SCSI board that ships with the S-6E is a completely worthless piece
of crap and should be tossed into the nearest trash can. Pick up a
cheap Adaptec and install the kernel drivers for it and you'll be fine
with that scanner. I used to run the same here with an AHA-1524 card
(at least, I think that was the number of the card, it's been awhile).
--
Steve Philp
Network Administrator
Advance Packaging Corp.
[EMAIL PROTECTED]
--
João Carlos [EMAIL PROTECTED]
Brasil - SP ICQ - 33.965.439
usuário Linux # 106644