i had the same problem on my 4015CDS... how do u fix this?
- Original Message -
From: Theo Brinkman [EMAIL PROTECTED]
To: [EMAIL PROTECTED]
Sent: Thursday, July 08, 1999 5:49 AM
Subject: Re: [newbie] Satellite 4080CDT
Martin White wrote:
A work colleague of mine has just installed Mandrake 6 on his new Toshiba
Satellite 4080 CDT. The install went fine (okay, we had to skip the X
config
as i know the video is only supported by a 'custom' X server i have
located
for him).
After rebooting into run level 3, the keyboard is locked and you can do
nothing but hit the power button - networking wasn't setup during install
as it uses a PCMCIA card that wasn't listed - so i thought we'd do it
later.
This means i can't telnet on and change runlevels.
I'm at a bit of a loss. If i boot to runlevel 1 using 'linux single'
everything is fine (after fixeing the filesystem problems caused by having
to hit the power button). But i don't know how to strip out all unnesscary
daemons from RL3 - if i run setup from RL1, i only get to set the daemons
that i want loaded for RL1.
Where do i start to get this up and running for him ?? - any ideas ?
Thanks,
Martin.
Sounds like this is a problem for the whole 40xx series. I've got a
4000CDT with the same trouble. There's a bit of info from someone who
had similar problems after upgrading kernels (or adding APMd, he's not
sure). The info is the following URL:
'http://www.submm.caltech.edu/~shimpei/laptop/#keyboard'
Updating the pcmcia-cs doesn't seem to do any good, and I don't know
enough to do either of the other two suggestions.
