[newbie] LAN and eth0 loading

[Marek M]

The problem is that my eth card doesnt want to load while starting linux
M8.0. How to fix it ? DAMN!




som errors i dont understand.
- Original Message -
From: Anuerin G.Diaz [EMAIL PROTECTED]
To: mandrake 
Sent: Thursday, November 29, 2001 9:18 AM
Subject: Re: [newbie] Servers


 On Wed, 28 Nov 2001 06:55:58 -0500, Jose M. Sanchez
[EMAIL PROTECTED] wrote:


snip

WHAT?

Check out SMBClient and SMBMount...

All Komba2 does is invoke these programs, which are part of Samba.

I.E.

smbclient -L \\Windowsmachine -U Validuser 

Where validuser is a username that you have used at least once at
your
Winblows box to log into the network. (this is important!).

If you can do this Samba will let you utilize Winblows printers from
Linux, even WinPrinters (read brain damaged printers)!

Lisa/Reslisa let's Konqueror BROWSE Winblows shares as well.

-JMS

 hi,

any tips on configuring LISA? the document that it came with is too
cryptic and ,even if I followed all the instruction, the LISA tab in the
configuration still displays the 'not yet configured' message. ill look into
komba since I dont use konqueror much (I use xwc).

 ciao!




 --

 Programming, an artform that fights back.

 ===

 Anuerin G. Diaz
 Design Engineer
 25/F Equitable-PCI Tower
 ADB Ave. cor. Poveda St.,
 Ortigas Center, Pasig City,
 Philippines 1605

 Tel no: (632) 6383070 loc 75
 ===








 Want to buy your Pack or Services from MandrakeSoft?
 Go to http://www.mandrakestore.com




-- 

Tego nie znajdziesz w zadnym sklepie!
[ http://oferty.onet.pl ]




Want to buy your Pack or Services from MandrakeSoft? 
Go to http://www.mandrakestore.com

Re: [newbie] LAN and eth0 loading

[Dennis Myers]

On Wednesday 28 November 2001 20:51, you wrote:
 The problem is that my eth card doesnt want to load while starting linux
 M8.0. How to fix it ? DAMN!




 som errors i dont understand.
  Go to http://www.mandrakestore.com
Have you tried the command 
ifup eth0  or  eth1   wichever your card is?
if that gets an error message then try 
insmod 1839rtl  or  again what ever module your card would be.  You should be 
able to see it from the Mandrake Control Center Hardware   and then ethernet 
or network card.  HTH
-- 
Dennis M.



Want to buy your Pack or Services from MandrakeSoft? 
Go to http://www.mandrakestore.com

Re: [newbie] LAN and eth0 loading

[Dennis Myers]

On Wednesday 28 November 2001 20:51, you wrote:
 The problem is that my eth card doesnt want to load while starting linux
 M8.0. How to fix it ? DAMN!




 som errors i dont understand.
 - Original Message -

I forgot to mention that you can look in your /etc/modules.conf  file to see 
if you see a line that says 
alias eth0  8139too   or something similar for your ethernet card. (w/o the 
quotes of course) .   Hope I'm not going over trampled ground. HTH
-- 
Dennis M.



Want to buy your Pack or Services from MandrakeSoft? 
Go to http://www.mandrakestore.com