Re: [Repeater-Builder] Micor Station question

[Captainlance]

no mods required, other than tuning. I have 2 on 441, both pout out rated 
power. check the regulated 12 volts to the tripler, the molex plugs on the 
interface board tend to be intermittent and /or resistive...
the exciter board should be making about 350mw to 500 mw..if working correctly.
lance n2HBA
  - Original Message - 
  From: w7nikw7nik 
  To: Repeater-Builder@yahoogroups.com 
  Sent: Wednesday, September 16, 2009 10:30 PM
  Subject: [Repeater-Builder] Micor Station question


I have a micor station 450-470 . I have .019 watts out the exciter after 
the 1st band pass tfd6373a. The tripler needs modified. The test meter 5 output 
is 34ma. Where can I find the mods for the tfe6153a tripler?
  The transmit freq is 441.850, I tried 445.550 element 1 watt with out tunning 
. I have narrowed it down to the tripler . Should I add some more wire to the 
turns on the 2nd band pass ?? Any help would be great . 



  


--



  No virus found in this incoming message.
  Checked by AVG - www.avg.com 
  Version: 8.5.409 / Virus Database: 270.13.101/2376 - Release Date: 09/16/09 
11:21:00

[Repeater-Builder] Micor Station question

[w7nikw7nik]

I have a micor station 450-470 . I  have .019 watts out the exciter after the 
1st band pass tfd6373a. The tripler needs modified. The test  meter 5 output is 
34ma. Where can I find the mods for the tfe6153a  tripler?
The transmit freq is 441.850, I tried 445.550 element 1 watt with out tunning . 
I have narrowed it down to the tripler . Should I  add some more wire to the 
turns on the 2nd band pass ?? Any help would be great . 

[Repeater-Builder] Micor Station question

[Nick]

I have some micor  repeaters with the Factory encode boards. I would like to 
make them half duplex. I can not get the board to transmit pl encode on ptt/mic 
or local. I see the pl on the scope on the exciter but not out the audio path. 
Any ideas?? Good thing i have manual or i would be lost. I am making link 
radios half dulpex.
 The encode boards are the pl not the boards that need decode valid. I thought 
I had the wrong board. Might have to give up and use after market.