Only install der 4xx-EMAC interrupt handlers *after* the core
network driver is registered.
This problem was noticed on the APM Taishan 440GX board, where
the board hung upon bootup after displaying "Net:".
Signed-off-by: Stefan Roese
---
drivers/net/4xx_enet.c | 14 +++---
1 files changed, 7 insertions(+), 7 deletions(-)
diff --git a/drivers/net/4xx_enet.c b/drivers/net/4xx_enet.c
index b1763b1..f328574 100644
--- a/drivers/net/4xx_enet.c
+++ b/drivers/net/4xx_enet.c
@@ -2035,6 +2035,13 @@ int ppc_4xx_eth_initialize (bd_t * bis)
dev->send = ppc_4xx_eth_send;
dev->recv = ppc_4xx_eth_rx;
+ eth_register(dev);
+
+#if defined(CONFIG_MII) || defined(CONFIG_CMD_MII)
+ miiphy_register(dev->name,
+ emac4xx_miiphy_read, emac4xx_miiphy_write);
+#endif
+
if (0 == virgin) {
/* set the MAL IER ??? names may change with new spec
??? */
#if defined(CONFIG_440SPE) || \
@@ -2072,13 +2079,6 @@ int ppc_4xx_eth_initialize (bd_t * bis)
dev);
virgin = 1;
}
-
- eth_register (dev);
-
-#if defined(CONFIG_MII) || defined(CONFIG_CMD_MII)
- miiphy_register (dev->name,
-emac4xx_miiphy_read, emac4xx_miiphy_write);
-#endif
} /* end for each supported device */
return 0;
--
1.7.6
___
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot