Public bug reported: The wireless stopped working after update and so did the wired. The wireless gives this in dmesg: [ 55.623817] iwl3945 0000:03:00.0: firmware: requesting iwlwifi-3945-2.ucode [ 55.839738] iwl3945 0000:03:00.0: loaded firmware version 15.32.2.9 [ 55.909095] Registered led device: iwl-phy0::radio [ 55.909117] Registered led device: iwl-phy0::assoc [ 55.909176] Registered led device: iwl-phy0::RX [ 55.909194] Registered led device: iwl-phy0::TX [ 55.966425] ADDRCONF(NETDEV_UP): wlan0: link is not ready [ 57.428863] sky2 eth0: Link is up at 100 Mbps, full duplex, flow control both [ 57.429073] ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready [ 57.928117] lo: Disabled Privacy Extensions [ 62.035121] [drm] TV-14: set mode NTSC 480i 0 [ 62.175386] [drm] TV-14: set mode NTSC 480i 0 [ 62.463084] [drm] TV-14: set mode NTSC 480i 0 [ 62.603075] [drm] TV-14: set mode NTSC 480i 0 [ 62.895096] [drm] TV-14: set mode NTSC 480i 0 [ 63.035305] [drm] TV-14: set mode NTSC 480i 0 [ 68.140019] eth0: no IPv6 routers present [ 103.311365] [drm] TV-14: set mode NTSC 480i 0 [ 103.451525] [drm] TV-14: set mode NTSC 480i 0 [ 103.779062] [drm] TV-14: set mode NTSC 480i 0 [ 103.919131] [drm] TV-14: set mode NTSC 480i 0 [ 104.196974] [drm] TV-14: set mode NTSC 480i 0 [ 104.338064] [drm] TV-14: set mode NTSC 480i 0 [ 168.208594] wlan0: authenticate with AP 00:1d:0f:ba:03:ca [ 168.210322] wlan0: authenticated [ 168.210327] wlan0: associate with AP 00:1d:0f:ba:03:ca [ 168.214571] wlan0: RX AssocResp from 00:1d:0f:ba:03:ca (capab=0x431 status=0 aid=1) [ 168.214578] wlan0: associated [ 168.216500] ADDRCONF(NETDEV_CHANGE): wlan0: link becomes ready [ 168.315661] cfg80211: Calling CRDA for country: ZA [ 168.320077] cfg80211: Received country IE: [ 168.320082] cfg80211: Regulatory domain: ZA [ 168.320086] (start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp) [ 168.320092] (2402000 KHz - 2494000 KHz @ 40000 KHz), (10000 mBi, 10000 mBm) [ 168.320096] cfg80211: CRDA thinks this should applied: [ 168.320099] cfg80211: Regulatory domain: ZA [ 168.320102] (start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp) [ 168.320107] (2402000 KHz - 2482000 KHz @ 40000 KHz), (N/A, 2000 mBm) [ 168.320113] (5170000 KHz - 5250000 KHz @ 20000 KHz), (300 mBi, 1700 mBm) [ 168.320118] (5250000 KHz - 5330000 KHz @ 20000 KHz), (300 mBi, 2000 mBm) [ 168.320123] (5490000 KHz - 5710000 KHz @ 20000 KHz), (300 mBi, 2000 mBm) [ 168.320128] (5735000 KHz - 5835000 KHz @ 20000 KHz), (300 mBi, 3000 mBm) [ 168.320132] cfg80211: We intersect both of these and get: [ 168.320135] cfg80211: Regulatory domain: 98 [ 168.320138] (start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp) [ 168.320143] (2402000 KHz - 2482000 KHz @ 40000 KHz), (N/A, 2000 mBm) [ 168.320152] cfg80211: Leaving channel 5180 MHz intact on phy0 - no rule found in band on Country IE [ 168.320157] cfg80211: Leaving channel 5200 MHz intact on phy0 - no rule found in band on Country IE [ 168.320162] cfg80211: Leaving channel 5220 MHz intact on phy0 - no rule found in band on Country IE [ 168.320166] cfg80211: Leaving channel 5240 MHz intact on phy0 - no rule found in band on Country IE [ 168.320171] cfg80211: Leaving channel 5260 MHz intact on phy0 - no rule found in band on Country IE [ 168.320176] cfg80211: Leaving channel 5280 MHz intact on phy0 - no rule found in band on Country IE [ 168.320180] cfg80211: Leaving channel 5300 MHz intact on phy0 - no rule found in band on Country IE [ 168.320185] cfg80211: Leaving channel 5320 MHz intact on phy0 - no rule found in band on Country IE [ 168.320189] cfg80211: Leaving channel 5745 MHz intact on phy0 - no rule found in band on Country IE [ 168.320194] cfg80211: Leaving channel 5765 MHz intact on phy0 - no rule found in band on Country IE [ 168.320199] cfg80211: Leaving channel 5785 MHz intact on phy0 - no rule found in band on Country IE [ 168.320203] cfg80211: Leaving channel 5805 MHz intact on phy0 - no rule found in band on Country IE [ 168.320208] cfg80211: Leaving channel 5825 MHz intact on phy0 - no rule found in band on Country IE [ 168.320213] cfg80211: Current regulatory domain updated by AP to: ZA [ 168.320217] (start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp) [ 168.320222] (2402000 KHz - 2482000 KHz @ 40000 KHz), (N/A, 2000 mBm) [ 168.840223] padlock: VIA PadLock not detected. [ 178.324062] wlan0: no IPv6 routers present [ 213.473149] CE: hpet increasing min_delta_ns to 15000 nsec [ 214.662268] wlan0: disassociating by local choice (reason=3)
For the wired network I cannot get the settings through dhcp. I am able to connect if I set the ip, route, etc manually (ifconfig, route etc). Description: Ubuntu karmic (development branch) Release: 9.10 2.6.31-9-generic #29-Ubuntu SMP Sun Aug 30 17:39:23 UTC 2009 i686 GNU/Linux ** Affects: ubuntu Importance: Undecided Status: New -- Wireless and wired network stopped working after update https://bugs.launchpad.net/bugs/428844 You received this bug notification because you are a member of Ubuntu Bugs, which is subscribed to Ubuntu. -- ubuntu-bugs mailing list ubuntu-bugs@lists.ubuntu.com https://lists.ubuntu.com/mailman/listinfo/ubuntu-bugs