at an angle.
From: AF On Behalf Of Adam Moffett
Sent: Thursday, November 19, 2020 8:03 AM
To: af@af.afmug.com
Subject: Re: [AFMUG] OT: Unistrut Pipe Clamp
Might need a square washer the same width as the uni-strut to get the "stud
nut" tightened.
On 11/19/2020 8:47 AM, Adam Mof
Might need a square washer the same width as the uni-strut to get the
"stud nut" tightened.
On 11/19/2020 8:47 AM, Adam Moffett wrote:
They make single hole conduit hangers. https://bit.ly/3nCm5Up
Unistrut stud nut: https://bit.ly/3pHd920
Add 1/4-20 hex nuts and washers.
On 11/19/2020 1:40
They make single hole conduit hangers. https://bit.ly/3nCm5Up
Unistrut stud nut: https://bit.ly/3pHd920
Add 1/4-20 hex nuts and washers.
On 11/19/2020 1:40 AM, Steve Jones wrote:
You'd think this would exist. You could probably just twist the tits
on a standard clamp and go one size larger, b
You'd think this would exist. You could probably just twist the tits on a
standard clamp and go one size larger, but that probably would cause a
stress failure
On Thu, Nov 19, 2020, 12:18 AM Jason McKemie <
j.mcke...@veloxinetbroadband.com> wrote:
> Does anyone know if there is any sort of bracke
Does anyone know if there is any sort of bracket available that will allow
me to run a pipe at an adjustable angle in relation to a piece of
unistrut? They have clamps that will do 90 degrees or run parallel to the
unistrut, but nothing in between as far as I can tell. I really need
something tha
