lto:af-boun...@afmug.com] *On Behalf Of *George Skorup
>> *Sent:* Friday, June 10, 2016 2:54 PM
>> *To:* af@afmug.com
>> *Subject:* Re: [AFMUG] First ePMP AP
>>
>>
>>
>> ePTP is for low latency. I typically see less than 3ms average. Does not
>> suppor
>
> To clarify, all unchecked will scan them all?
>
>
>
>
>
>
>
> *From:* Af [mailto:af-boun...@afmug.com] *On Behalf Of *George Skorup
> *Sent:* Friday, June 10, 2016 2:54 PM
> *To:* af@afmug.com
> *Subject:* Re: [AFMUG] First ePMP AP
>
>
>
> eP
rge Skorup
*Sent:* Friday, June 10, 2016 2:54 PM
*To:* af@afmug.com
*Subject:* Re: [AFMUG] First ePMP AP
ePTP is for low latency. I typically see less than 3ms average. Does
not support GPS sync.
TDD PTP mode does support GPS sync. You can chose either 2.5 or 5ms
framing. Obviously the 2.5 f
Thanks very much guys
To clarify, all unchecked will scan them all?
From: Af [mailto:af-boun...@afmug.com] On Behalf Of George Skorup
Sent: Friday, June 10, 2016 2:54 PM
To: af@afmug.com
Subject: Re: [AFMUG] First ePMP AP
ePTP is for low latency. I typically see less than 3ms
ePTP is for low latency. I typically see less than 3ms average. Does not
support GPS sync.
TDD PTP mode does support GPS sync. You can chose either 2.5 or 5ms
framing. Obviously the 2.5 framing will get you lower latency, about the
same as Canopy (7-14ms).
The PTP modes buy you the higher EI
ePTP is only for PTP so set the mode to TDD.
On the SM, select the channel sizes to scan, then for each channel size the
frequencies to scan. On 2.4 I usually select all frequencies for the
channel sizes I'll use since it's just a few seconds to scan per channel
size.
On Thu, Jun 9, 2016 at 11:19
Hi Guys
Setting up my first ePMP Ap
I have over 100 Ubnt AP's but running out of capacity on them.
For PTMP do you guys normally use TDD or ePTP Master (whatever that is)
I notice on the sm you have to check specific frequencies, do you guys
just tick every second one in case you need to