To comment on the following update, log in, then open the issue: http://www.openoffice.org/issues/show_bug.cgi?id=49360 Issue #:|49360 Summary:|How to anchor with flexible vertical position, but |hard same page/no overlap requirement? Component:|Word processor Version:|680m101 Platform:|Other URL:| OS/Version:|FreeBSD Status:|UNCONFIRMED Status whiteboard:| Keywords:| Resolution:| Issue type:|FEATURE Priority:|P3 Subcomponent:|formatting Assigned to:|mru Reported by:|durian
------- Additional comments from [EMAIL PROTECTED] Mon May 16 14:18:40 -0700 2005 ------- Maybe it is possible to do this is 1.9. If so, kindly point me in the right direction. If it is not possible, consider this a feature request. I have a document where I want to insert frames containing images in the document's margins and anchor them to paragraphs or characters. I don't really care about the vertical position of the frame, but near the anchor point is better than far. However, I do want the frame to be on the same page as the anchor point. I also do not want frames to overlap. For example, if the anchor points of two frames are close to each other and near the bottom of the page, writer should put the bottom-most frame down at the bottom of the page and then push the other frame up high enough to avoid overlapping the lower frame. I don't want to manually fine tune the positioning as I want the document to adapt if I change page sizes or add/remove text. I was hoping the "fly frames" in 1.9 would allow me to do this, but I haven't been able to figure out how. --------------------------------------------------------------------- Please do not reply to this automatically generated notification from Issue Tracker. Please log onto the website and enter your comments. http://qa.openoffice.org/issue_handling/project_issues.html#notification --------------------------------------------------------------------- To unsubscribe, e-mail: [EMAIL PROTECTED] For additional commands, e-mail: [EMAIL PROTECTED] --------------------------------------------------------------------- To unsubscribe, e-mail: [EMAIL PROTECTED] For additional commands, e-mail: [EMAIL PROTECTED]