On Wed, Dec 10, 2003 at 05:56:21PM -0500, Shawn Sanders wrote:
> If my tapelist consists of 20 tapes will it rotate the index files after
> every rotation? I am currently using 2 sets of 20 tapes,that are labeled
> the same Tape-1 through Tape-20. Once I reach Tape-20 on the first set I
> rotate
If my tapelist consists of 20 tapes will it rotate the index files after
every rotation? I am currently using 2 sets of 20 tapes,that are labeled
the same Tape-1 through Tape-20. Once I reach Tape-20 on the first set I
rotate the entire set and replace with the other set's Tape-1. The tape set
i
Michael Packer wrote:
Hello,
When I start up amanda my load (which normally is very low) starts to climb.
I'm on RH Linux 8.0 dual xeon processor, 2 gig of memory. SCSI tape, raid array
on different channels... this high load continues for about 9-10 minutes
then it drops down to a load average o
Hello All,
Just built mtx 1.3.3 for new jukebox on SGI system, I'm assuming
that like my Solaris system the jukebox is addressed separately
from the actual tape drive ?
There are OS patches in place and I'm able to see the drive (SDLT 320)
but I'm uncertain about addressing the jukebox itself.
Hello,
When I start up amanda my load (which normally is very low) starts to climb.
I'm on RH Linux 8.0 dual xeon processor, 2 gig of memory. SCSI tape, raid array
on different channels... this high load continues for about 9-10 minutes
then it drops down to a load average of around 1.5.
2
Nevermind, Duh me.
Just add dir was it. Was confused since list didn't show all files and
directories.
-Original Message-
From: Shawn Sanders [mailto:[EMAIL PROTECTED]
Sent: Wednesday, December 10, 2003 1:01 PM
To: AMANDA Users
Subject: Amrecover add recursively
What would be the syntax
On Wed, 10 Dec 2003 at 1:00pm, Shawn Sanders wrote
> What would be the syntax of adding an entire directory structure to be
> included in the restore list?
>
> I can't seem to get it working for an entire directory, subdirectories and
> files in them.
> Being a huge directory structure I don't
Is it possible to make amanda avoid doing hostname lookups for
specific DLE's while still doing it for other (more important) DLE's?
I have a server on a reserved ip that is not in the DNS. With some fiddling
with /etc/hosts, /etc/host.conf, route add -host ... and /etc/resolv.conf
i have managed
What would be the syntax of adding an entire directory structure to be
included in the restore list?
I can't seem to get it working for an entire directory, subdirectories and
files in them.
Being a huge directory structure I don't want to have to manually traverse
each directory.
Thanks,
Shawn