Hi,
I've already solved the problem. I simply made an update and upgrade to my
BBB ant it solved the problem. Now i can plug and unplug my devices and
they are recognized by the BBB.
I discovered that some releases of Angstrom has that problem, I've tried a
few and some have and others
Hi,
Thank you for the response.
The boot issue i've solved it with a soft start circuit and now it is
working.
The hot plug problem, i'm still struggling to find a solution because i
can't find one, is there any suggestions to solve it?
Thanks.
Duarte Carona
Terça-feira, 27 de Maio de
Boot the board with your hub connected and after boot run the commands
below, then test hot-plug.
echo on /sys/bus/usb/devices/usb1/power/control
echo on /sys/bus/usb/devices/usb1/1-1/power/control
On Wed, May 28, 2014 at 6:04 AM, duartecar...@gmail.com wrote:
Hi,
Thank you for
Hi,
I've been working with USB Hub from Texas Instruments (TSUB2046BVF) and
i've tried to plug it to my BBB and everything works fine if i plug devices
before BBB boot up but when i unplug and plug again (hotplug) it is not
recognized.
Based on some forum posts I realized that this is a
Yes, there is a current restriction on boot up. It is part of the USB
standard and imposed by the PC. 100mA max until the ports is recognized by
the PC.
Gerald
On Mon, May 26, 2014 at 5:33 AM, duartecar...@gmail.com wrote:
Hi,
I've been working with USB Hub from Texas Instruments
On Mon, May 26, 2014 at 5:33 AM, duartecar...@gmail.com wrote:
Hi,
I've been working with USB Hub from Texas Instruments (TSUB2046BVF) and i've
tried to plug it to my BBB and everything works fine if i plug devices
before BBB boot up but when i unplug and plug again (hotplug) it is not
