Hi Jeremy
There can be lot of issue but here is what you should check:-
1. Check on Phones network configuratio and make sure they have the correct
TFTP server IP address.
2. Make sure CM service is running on SUB.
3. Make sure Auto-registration is enabled on PUB.
If all is well above, try
Hi Erwan
Make sure the CUE Dial-peer is properly configured and transcoding is
enabled.
- HTH
Regrads
- Basant
On Fri, Nov 28, 2008 at 8:19 PM, Erwan Erwan [EMAIL PROTECTED] wrote:
hi,
does anybody ever experience this ?
I hv config this and others also setup fine.
Hi everyone,
I have ran into this before and not sure how to fix it. Even though
NTP is configured on the router, CUE can not sychronize with it. Am I
missing something ?
Enter IP Address of the Primary NTP Server
(IP address, or enter for 10.1.202.1):
It appears that the www.proctorlabs.com website is intermittently
going down. Is anyone else experiencing this issue ? Also configs
were not reverted back on my pod and I was able to revert all the
routers and switches but not the servers (pub/sub/unity). I have
tried to revert the servers a few
Hi
I have the configuration for IPCC and I have two agents, onw in HQ and the
other in BR1, all is working without problems, but I am testing it in the
case of lack of bandwidth over the wan when the AAR kicks in, with AAR
active I can call from HQ and BR1 to the ICD pilot and if I have the
Hi, Mike and others.
We are getting the support pages and the guys are working feverishly to
diagnose and address the issues. Thanks for your patience.
We will be happy to provide a complimentary replacement session voucher to
compensate for lost time due to issues experienced on our side.
--
Yes, checked that. I can ping the cue from the HQ rtr.
Pod11-HQ-RTR#ping 10.1.202.2
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 10.1.202.2, timeout is 2 seconds:
!
Success rate is 100 percent (5/5), round-trip min/avg/max = 8/8/8 ms
I have tried resetting it. Still
So it appears that both MQC Shaping and Legacy Shaping cannot be
configured simultaneously on the HQ-RTRs wan interfaces.
Pod11-HQ-RTR(config-fr-dlci)#class FRMAPCLASS-SITEC
Remove frame-relay traffic shaping first before using GTS in Modular QoS CLI
So in the LAB, I would assume that we would
Pod11-BR2-RTR#sho ntp associations
address ref clock st when poll reach delay offsetdisp
*~10.1.200.3 127.127.7.1 81264 377 6.9 -3.00 0.4
* master (synced), # master (unsynced), + selected, - candidate, ~ configured
Pod11-BR2-RTR#sho
It was my laziness that led to this problem. I didn't configure the
excludes on my BR2 dhcp scope and a phone pulled the same IP as my
CUE. LOL. I won't do that again.
Thx everyone for your help.
Mike Brooks
CCIE#16027 (RS)
On Sat, Nov 29, 2008 at 11:43 AM, johan_claes [EMAIL PROTECTED]
All -
I have read in several forums that the 2006 Techtorial is a must read.
Anyone have it or have a link to a download site?
Jeff
11 matches
Mail list logo
