Interesting discussion, if we are using Datucha's itsp example:
Cube's default of media flow through would remark rtp towards the itsp based
on outbound voip dial peers dscp, however our internal call leg would retain
the rtp dscp value allocated on internal switch?
Or am I being a bit
But... if it passes the router, that does not mean the router has
originated that stream so it will not get remarked...
That's not correct, as I have made some tests, and the CUCME Router will
Mark/Re-Mark the RTP/Signaling QoS markings when the CUCME IP Phones call
the outside through the
I have made the test to prove it and here are the results:
IP Phone --- CUCM --- CUBE --- CUCME --- IP Phone
CUBE is placed between, so that I can match the DSCP marking on it through
the simple policy-map:
R1#sh policy-map interface ser 0/3/0.2 input
Serial0/3/0.2: DLCI 201 -
Hi Datucha,
Thanks for the good troubleshooting.
You are right in the case of CUCME - and I forgot the fact that CUCME
dial-peers are efxs ports. which means CUCME always re-originates the
traffic on behalf of IP Phones, hence the traffic being remarked.
Nice one.
Cheers,
On Sat, Dec 17, 2011
I have a Dell PowerEdge T110 for sale with the following setup.
CPU Cores: 4 CPUs x 2.526 GHz
Processor Type: Intel(R) Xeon(R) CPU X3440@ 2.53 GHz
Logical Processors: 8
Memory: 8 G
Hard drive: 1 TB
Software:
VMWare ESXi 4.1.0 (License
In RTMT is there a way to trigger just one alert and that's it, even if the
problem you're monitoring persists? So say I set it up to send an email if
my phones drop below a certain number registered, I want to send one and
only one email to the admin (I don't want to fill up his mailbox with an
Ya .. Tested this and same result
Regards,
Mohammed Al Baqari
Sent from my iPhone
On Dec 16, 2011, at 4:44 PM, datucha123 datucha123 datucha...@gmail.com wrote:
You are also experiencing the same for MTP on CUBE?
On Fri, Dec 16, 2011 at 3:37 PM, Mohd Baqari baqari.voic...@gmail.com
I wonder if you sent it back through the Lo0 interface if it would work.
- Reply message -
From: Mohd Baqari baqari.voic...@gmail.com
Date: Sat, Dec 17, 2011 6:16 pm
Subject: [OSL | CCIE_Voice] RFC2833 with MTP
To: datucha123 datucha123 datucha...@gmail.com
Cc:
Hello,
What is the command to reduce the SCCP failover timer ?
Currently it takes approximately 5 minutes to register to my gateway.
sccp ccm 10.10.210.11 identifier 1 version 6.0
sccp ccm 10.10.210.10 identifier 2 version 6.0
sccp ccm 10.10.110.3 identifier 3 version 6.0
sccp
sccp ccm group 1