Used pod 12 last night without incident.
Brian
----- Reply message -----
From: "Matthew Berry" <ciscovoiceg...@gmail.com>
Date: Sun, Jun 13, 2010 5:09 pm
Subject: [OSL | CCIE_Voice] VMware Connectivity and VLAN Interface Issues
To: "OSL Group" <ccie_voice@onlinestudylist.com>
Has anyone else experienced issues with Pod 12 on PL?
I am using that pod right now and have two issues that prevent me from
moving forward.
Issue 1: I can ping the virtual servers from my own hardware and from
the remote routers. However, I cannot load the web page admin nor can
I SSH into the CUCM/CUC devices.
Issue 2: BR1 gateway has a "line protocol down" for VLAN interfaces 130
and 240. I mentioned this on the OSL a few weeks prior. The basic
issue is that those interfaces will never show an UP/UP state. I have
reloaded the router, removed configs, compared with previous working
configs, etc. Still no dice. I made sure that the interfaces were
configured properly. In fact, the same configuration works on BR2
(different VLAN ID and IPs, off course).
Below are some outputs to defend issue two:
BR1-RTR#show int vlan 130
Jun 14 00:44:05.575: %SYS-5-CONFIG_I: Configured from console by console
BR1-RTR#show int vlan 130
Vlan130 is up, line protocol is down
Hardware is EtherSVI, address is 0017.9460.8d40 (bia 0017.9460.8d40)
Internet address is 10.10.101.1/24
MTU 1500 bytes, BW 100000 Kbit/sec, DLY 100 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
ARP type: ARPA, ARP Timeout 04:00:00
Last input never, output never, output hang never
Last clearing of "show interface" counters never
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/40 (size/max)
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
0 packets input, 0 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 packets output, 0 bytes, 0 underruns
0 output errors, 0 interface resets
0 unknown protocol drops
0 output buffer failures, 0 output buffers swapped out
BR1-RTR#show ip int vlan 130
Vlan130 is up, line protocol is down
Internet address is 10.10.101.1/24
Broadcast address is 255.255.255.255
Address determined by setup command
MTU is 1500 bytes
Helper address is not set
Directed broadcast forwarding is disabled
Multicast reserved groups joined: 224.0.0.5
Outgoing access list is not set
Inbound access list is not set
Proxy ARP is enabled
Local Proxy ARP is disabled
Security level is default
Split horizon is enabled
ICMP redirects are always sent
ICMP unreachables are always sent
ICMP mask replies are never sent
IP fast switching is enabled
IP fast switching on the same interface is disabled
IP Flow switching is disabled
IP CEF switching is enabled
IP CEF switching turbo vector
IP Null turbo vector
IP multicast fast switching is enabled
IP multicast distributed fast switching is disabled
IP route-cache flags are Fast, CEF
Router Discovery is disabled
IP output packet accounting is disabled
IP access violation accounting is disabled
TCP/IP header compression is disabled
RTP/IP header compression is disabled
Policy routing is disabled
Network address translation is disabled
BGP Policy Mapping is disabled
WCCP Redirect outbound is disabled
WCCP Redirect inbound is disabled
WCCP Redirect exclude is disabled
BR1-RTR#show vlan-switch brief
VLAN Name Status Ports
---- -------------------------------- ---------
-------------------------------
1 default active Fa1/0, Fa1/1, Fa1/2, Fa1/3
Fa1/4, Fa1/5, Fa1/6, Fa1/7
Fa1/8, Fa1/9, Fa1/10,
Fa1/11
Fa1/12, Fa1/13, Fa1/14,
Fa1/15
130 DATA active
240 PHONES active Fa1/1, Fa1/2, Fa1/3, Fa1/4
Fa1/5, Fa1/6, Fa1/7, Fa1/8
Fa1/9, Fa1/10, Fa1/11,
Fa1/12
Fa1/13, Fa1/14, Fa1/15
1002 fddi-default act/unsup
1003 token-ring-default act/unsup
1004 fddinet-default act/unsup
1005 trnet-default act/unsup
interface FastEthernet1/1
switchport trunk native vlan 130
switchport mode trunk
switchport voice vlan 240
spanning-tree portfast
!
interface FastEthernet1/2
switchport trunk native vlan 130
switchport mode trunk
switchport voice vlan 240
spanning-tree portfast
!
interface Vlan130
ip address 10.10.101.1 255.255.255.0
!
interface Vlan240
ip address 10.10.201.1 255.255.255.0
ip helper-address 10.10.200.3
--
*Matthew Berry*
/A+, CCENT, CCNA, CCNA Voice, CCVP, CCIE Voice Written/
*_Vitals:_*
*GVoice: *+1.612.424.5044
*Gmail*: ciscovoiceg...@gmail.com
*Skype*: ciscovoiceguru
_______________________________________________
For more information regarding industry leading CCIE Lab training, please visit
www.ipexpert.com
