Hi Guys,
Agreed.. it is a bug in 7.0.. fixed in an ES and then in 7.1(2) - CSCsy08872
Are you familiar with the vmware settings?
Are you using bridged mode?
Do you have a network interface configured for that VMware network on your
host PC?
If all of your network settings seem ok, then are you r
I can confirm that as well, I get that message on my switch constantly, not
entirely sure why..
That said, console into your PUB and sub and verify networking is up and
running
$ show network eth0
Verify it has an IP address, verify it has a gateway. Make sure routing is
also setup properly.
On
VMWare even
On Fri, Jun 26, 2009 at 9:51 AM, Ron Cannella wrote:
> The duplex mismatch is an bug with WM as I understood it. Just do "no cdp
> enable" on F1/0/4
>
> That is probably not your connectivity issue to the PUB/SUB
>
>
>
> 2009/6/26 Juliana Xu
>
> Hi,
>>
>> I'm in the middle of the s
The duplex mismatch is an bug with WM as I understood it. Just do "no cdp
enable" on F1/0/4
That is probably not your connectivity issue to the PUB/SUB
2009/6/26 Juliana Xu
> Hi,
>
> I'm in the middle of the session, but I can't ping cucm pub and sub, see
> the error message:
>
> "%CDP-4-DUPL
Hi,
I'm in the middle of the session, but I can't ping cucm pub and sub, see the
error message:
"%CDP-4-DUPLEX_MISMATCH: duplex mismatch discovered on FastEthernet1/0/4 (not
half duplex), with CUC7-Pub eth0 (half duplex)."
I changed port to half duplex, but still I can't ping pub and sub. Any
