Re: [OSL | CCIE_Voice] Secondary Dialtone - CME

2008-01-30 Thread Devildoc
that you take a good look at your incoming and outgoing COR lists from the phone that you use to dial 9 and see if there is any permission issue. JD Date: Wed, 30 Jan 2008 15:08:20 -0600From: [EMAIL PROTECTED]: [EMAIL PROTECTED]; [EMAIL PROTECTED]: Re: [OSL | CCIE_Voice] Secondary Dialtone - CME

Re: [OSL | CCIE_Voice] Secondary Dialtone - CME

2008-01-30 Thread ovais Iqbal
try what I have suggested if you have time, just try the basic config and see where are you breaking out. On 1/30/08, Priyank Kiran <[EMAIL PROTECTED]> wrote: > > Excatly, I have never seen this before myself. Must have done at least 20 > CMEs before. Idid scrap the entire config & re-did it, but

Re: [OSL | CCIE_Voice] Secondary Dialtone - CME

2008-01-30 Thread Priyank Kiran
Excatly, I have never seen this before myself. Must have done at least 20 CMEs before. Idid scrap the entire config & re-did it, but not through the "telephony-service setup". I was wondering if there were any "debug commands" that could help this. I am using CME version 4.1 Thanks! On Jan 30

Re: [OSL | CCIE_Voice] Secondary Dialtone - CME

2008-01-30 Thread ovais Iqbal
this is strange, what version of CME is this one? may be if time does not permit to troubleshoot it further then you could take a backup of your config and do the following: 1- backup your runn-config 2- do *no telephoney-service* 3- Reload the router 4- do Telephoney-service setup 5- put the basi

Re: [OSL | CCIE_Voice] Secondary Dialtone - CME

2008-01-30 Thread Priyank Kiran
Ovais: Thanks for the repsonse. Did all whatever you mentioned before. In fact I also tries changing the secondary-dialtone from 9 to other nos. like 7 or 8, same result (fast busy tone). It is something like it does not recognize that pattern. for exapmle I do not have any patterns that begin wi

Re: [OSL | CCIE_Voice] Secondary Dialtone - CME

2008-01-30 Thread ovais Iqbal
what do you hear when you press 9 if you leave that command in? and what if you remove this command and check if there is any difference? other wise the best thing with CME would be to do two things as follows: - reset the phones or - reload the router. Thanks Ovais. On 1/30/08, Priyank Kiran

[OSL | CCIE_Voice] Secondary Dialtone - CME

2008-01-30 Thread Priyank Kiran
Hi, What could be the reason for the secondary-dialtone not working on a CME router ? I have the command "secondary-dialtone 9" under the telephony-service. Thank you ! ip cef no ip dhcp use vrf connected ip dhcp excluded-address 192.168.240.1 192.168.240.50 ip dhcp excluded-address 192.168.240.