RE: Don't think this is true ! Re: CCIE One-Day Lab layout [7:18348]

think this code is still pretty bleeding edgeit will get there and when it does it is very powerfuluntil then can you hand me a suture? Felice Russell CCNP -Original Message- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]]On Behalf Of Michael L. Williams Sent: Monday, September 03

RE: what is the difference between tacas+ and radius

http://www.cisco.com/warp/public/480/10.html here is a link to the cisco compaison of radius and tacacs -Original Message- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]]On Behalf Of JCoyne Sent: Friday, December 22, 2000 6:38 AM To: [EMAIL PROTECTED] Subject: Re: what is the

line down

Jason - Have you checked the status of DTR (etc) under the show interface seril # command? If you are in fact getting signel- you want to check to see if the lmi are communicating. Basically this should happen if the switch and router are communicating. If they are not - verify you are using the

ospf summarization metric answer

document fixes routing loops which can occur in RFC 1583 when the same external destination is advertised by AS boundary routers in separate areas. There are two manifestations of this problem. The first, discovered by Dennis Ferguson, occurs when an aggregated forwarding address is

OSPF summarization metrics

Helo Folks, I have run into a bit of an oddity. In code 11.3 and 12.1 when you use ospf address summarization the routes advertised have the best route metric. With code 12.0 it has the worst path metric. Which is correct? Several people I have spoken with said the 12.0 code is handeling the

Switch Limitations?

Hi I have a question about switch configuration limits- what i have are four standalone cat 3500xl with gbic uplinks and one cabletrom MMAC acting as a backbone. There are two routers- one connected to one network and the MMAC and the other connecting to one of the cats. There are several hubs