why there is an ethernet frame size limitation

Hello Guys: What i want to know is why there is a limit that ethernet frame size cannot be less than 64 bytes and more than 1526 bytes. I know that this is how ethernet should be understand but whats the logic behind it. Similarly why we are limiting cell size of ATM to 53 bytes. Regards Azhar Soo

Re: [configure router thru aux port]

The auxiliary port is used for remote access to the router through an asynchronous modem. You have to assign an ip address to the asynchronous interface mapped to the auxiliary port on a router. The auxiliary password is used to set a password for the aux. port . This port is used to connect a mo

bgp problem

A BGP speaker must never advertise an address of a peer to that peer as a NEXT_HOP , for a route that the speaker is originating. Can I anyone explain it. Thanks Azhar Soomro Get free email and a permanent address at http://www.

Re: [Reverse Telnet]

Hello: You can consult the following URL http://www.cisco.com/univercd/cc/td/doc/product/software/ios120/12cgcr/dial_c/dcrtelnt.htm Regards Azhar Soomro "ALI SHEERAZ" <[EMAIL PROTECTED]> wrote: hello, I want a reverse telnet session to a modem thru a 2501 router ,how can it be possible...a

Re: [Re: x.25 question help]

The Maximum Speed for X.25 is 2MB/s Regards Azhar Soomro "Guy Tal" <[EMAIL PROTECTED]> wrote: - Original Message - From: "Zhang Jin" <[EMAIL PROTECTED]> Newsgroups: groupstudy.cisco To: <[EMAIL PROTECTED]> Sent: Monday, November 20, 2000 7:58 PM Subject: x.25 question help > Dear grou

Re: [Re: How to determine CIR and increase CIR of FR? [7:203]

Well normally when u r configuring eigrp on frame-relay network, let suppose u give 128 k bandwidth, u know that eigrp uses 50 percent of the bandwidth, so it will use 64 k of the bandwidth of the interface.. And we know normally the serial interface is 64 K so it will make use of all the bandwidt

Re: [How to clear counters on a specific port. [7:9896]

You can use clear counters command for clearing counters on all ports or clear counters module/port command. Regards AZHAR SOOMRO "Washington Rico" wrote: Anyone know how to clear counters for a specific port. I need to clear counters on a specific port instead of clear all the counters on

colt link is not working [7:12352]

Can anyone please tell me what is the exact URL for using COLT testing now because the previous URL http://www.cisco.com/cgi-bin/front.x/wwtraining/colt/ColtLogin.pl is not working. Any help will be greatly appreciated. Thanks Azhar Mumtaz. Message Posted at: http://www.groupstudy.com/form

what happens to the COLT link [7:12431]

Will somedboy help me how to get access to the COLT online testing means = cisco online testing . The previous URL is not working. Any help will be greatly appreciated. Thanks azhar Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=12431&t=12431 -

Re: [What is Keepalives???]

Detect (CD) signal.Because this sort of failure is typically noticed within a few milliseconds, adjusting the keepalive timer for quicker routing recovery is generally not useful. Regards: Azhar Mumtaz [EMAIL PROTECTED] wrote: Does anyone have a short good definition of what a keepalive is

cmtd book

Hi: Can any one help me where on the net i can buy CMTD book. Regards Azhar Mumtaz Get free email and a permanent address at http://www.netaddress.com/?N=1 ___ UPDATED Posting Guidelines: http