Hi,
When should one use the command "neighbor x.x.x.x ebgp-multihop"?
Some cisco document on the web just says as follows:
- "Use the ebgp-multihop command only when the ip address you are peering
to
on your eBGP peer is not directly connected"
Any help will be appreciated.
Thanks
BS Kan
Hi,
This command is used when trying to load balance with
an ebgp peer. Typically this is when your neighbour
statement is mapped to the ebgp peers loopback
address.
Regards
Jonathan
--- "Kang, Byeong Soo"
wrote:
> Hi,
>
> When should one use the command "neighbor x.x.x.x
> ebgp-multihop"
ect: "ebgp-multihop" command [7:24482]
> Hi,
>
> When should one use the command "neighbor x.x.x.x ebgp-multihop"?
>
> Some cisco document on the web just says as follows:
> - "Use the ebgp-multihop command only when the ip address you are peering
&
You need this command when you are talking to a neighbor not connected to
the same IP segment. For instance, if the serial interfaces are numbered
and you want to talk loopback interface to loopback interface, you need the
multihop because the serial interface addresses are between the loopback
a
rface, so make sure you make a static route to reach
>the peer`s loopback also.
>
>HTH
>
>- Original Message -
>From: "Kang, Byeong Soo"
>To:
>Sent: Monday, October 29, 2001 9:38 PM
>Subject: "ebgp-multihop" command [7:24482]
>
>
>>
t;
>Reply-To: "Darren Crawford"
>To: [EMAIL PROTECTED]
>Subject: Re: "ebgp-multihop" command [7:24482]
>Date: Mon, 29 Oct 2001 13:43:22 -0500
>
>Except when you're in the lab exam and you can't use static routes. ;^)
>
>Darren
>
>At 08:49
AM
To: [EMAIL PROTECTED]
Subject: Re: "ebgp-multihop" command [7:24482]
Except when you're in the lab exam and you can't use static routes. ;^)
Darren
At 08:49 AM 10/29/2001 -0500, Engelhard M. Labiro wrote:
>Hi,
>
>Normaly use ebgp-multihop if you put the IP addr
mand
> when configuring bgp load balancing using loopbacks
> and static routes to get
> to the loopbacks! Any ideas then?
>
>
> >From: "Darren Crawford"
> >Reply-To: "Darren Crawford"
> >To: [EMAIL PROTECTED]
> >Subject: Re: "ebgp-multih
8 matches
Mail list logo