Re: [c-nsp] Full BGP Feed Convergence Time on ASR 1006 RP2 Setup

Not exactly your scenario, but an ASR1006 w/RP2 can get stable in ~40 secs with two route-reflectors carrying full routes: Almost...notice the InQ NeighborV AS MsgRcvd MsgSent TblVer InQ OutQ Up/Down State/PfxRcd x.x.x.x 4X 98486 5 406609 154

Re: [c-nsp] Brocade Vs Cisco

On Tuesday, August 16, 2011 08:03:59 AM McDonald Richards wrote: There have been issues inter-oping MPLS L2VPN with the Cisco gear (in our deployment) so I'd stick to a single vendor for your PE device and try to avoid using LDP at all on the CES/CER platform as it does not scale as well

[c-nsp] Cisco 3750 startup-config file open failed (Device or resource busy)

All I have a problem with my 3750 which i have inserted here: *write* *startup-config file open failed (Device or resource busy)* * * I have looked up and see you clear a particular line where the idea is another user has locked up the nvram. i don't have another user logged into my router: sh

Re: [c-nsp] MTU - issue while doing VPLS over VPLS!

Dipesh, As nobody has replied, maybe you should seek the services of a consultant or your local Cisco reseller. Peter -- Peter Hicks peter.hi...@poggs.co.uk ___ cisco-nsp mailing list cisco-nsp@puck.nether.net

Re: [c-nsp] BGP router upgrade

Thank you all for the feedback on the subject. It is much appreciated. Looking at the facts that the sup720 engine will hold full bgp table and do 30 mpps (400 mpps with dfc), it beats the 3945 (982 kpps), npe-g2 (2 mpps) it looks like a good investment compared to raw performance and needs.

[c-nsp] remote location voice qos with switches

Hello, I have a remote location, where I have a 3560 which connects to our main location via a wireless bridge and goes into a 3560G. The wireless bridge has approximately 70mbps throughput. This remote location has about 12 7962 phones, and for the most part everything works fine, except when

Re: [c-nsp] remote location voice qos with switches

On 8/16/2011 8:47 PM, Dan Letkeman wrote: Hello, I have a remote location, where I have a 3560 which connects to our main location via a wireless bridge and goes into a 3560G. The wireless bridge has approximately 70mbps throughput. This remote location has about 12 7962 phones, and for the

[c-nsp] secondary addresses on 3524

I've got a cisco 3524 running IOS 12.0 which accepts 'ip x.x.x.x y.y.y.y secondary' on its vlan interface but the command appears to be ignored. Anyone know if secondary addresses are supported on this switch? Online docs seem to suggest so but maybe 12.0 is too old? -- Antonio Querubin

[c-nsp] 6500 SNMP interface CRC oid

I m looking for SNMP 6500 interface CRC input error OID. Which MIB should i use? Thanks for your feedback ___ cisco-nsp mailing list cisco-nsp@puck.nether.net https://puck.nether.net/mailman/listinfo/cisco-nsp archive at