I do some vlan rewrites/aggregation at a POP with the configuration below.
Everything works as expected.
However, it would be nice to see which mac addresses which are mapped to each
vlan. My understanding is that the vlan is popped at incoming traffic and added
to outgoing traffic. It is possib
Is this a trick question ?
Every time it sees a packet that matches the criteria you have specified and is
put into your class it increments the "packets" counter by 1 and adds the size
of the packet to the "bytes" counter.
What is or isn't happening that you're concerned about ?
regards,
To
The policy should look similar to:
route-policy rp_ramjet-export
if community matches-any cs_local-aggregates or community matches-any
cs_customer-routes or community matches-any cs_customer-attached-routes then
pass
else
drop
endif
end-policy
adam
> @alan - carrier-delay msec 0 did not seem to make any difference, I still
lost 5 pings. I simply turned it on the single interface I am testing with
and assumed it will kick in.
Doesn't the carrier-delay msec 0 affect only the down events if "up|down"
knob is supported by any chance?
Have you t
Hi there Waris,
We've got quite a few of the ME3600's deployed now, which we migrated to over
and above a legacy 3750ME estate. The big point for us was to migrate to MPLS
access rather than have any spanning tree knocking about in the Core.
Favoured points from my team involves the ease of co
I see so the islands are stitched together over the CsC L3VPN, since all
islands have the same AS together they act like a common AS.
And the CsC L3VPN is provided by the underlying common backbone
Inter-AS-MPLS optC style.
Right?
So all access nodes within a particular island have RSVP-TE tunne
Good point, SDM is just another gotcha. Allocate according to use and
complain in the log when your getting close to max.
ME3600x + ASR9k FTW! Just make more physical variants of the ME and lower
the price on ASR9k.
On Thu, Jul 25, 2013 at 12:56 PM, Leigh Harrison <
lharri...@convergencegroup.co
+1 on last comment
2013/7/25 Mattias Gyllenvarg
> Good point, SDM is just another gotcha. Allocate according to use and
> complain in the log when your getting close to max.
>
> ME3600x + ASR9k FTW! Just make more physical variants of the ME and lower
> the price on ASR9k.
>
>
> On Thu, Jul 25,
(Apologies to people who've seen the other half of this on j-nsp)
Has anyone seen an N7k sending LACP PDUs tagged with the following config:
vlan dot1Q tag native
int eth3/1
channel-group 20 mode active
int po20
switchport
switchport mode trunk
switchport trunk native vlan 111
switchpo
Greetings List,
I have been trying to hunt down some definitive answers regarding
interoperability using non-cisco AP's running CAPWAP in conjunction with a
Cisco WLC 5508 running 7.3.101.0.
A TAC case I opened on this issue didn't really give me a definitive answer
only to say that a non-cisc
Hi,
> Can anybody tell me if this is still the current state of CAPWAP?
> Has anybody seen or had experience running a multi-vendor AP deployment using
> Cisco WLC's ?
I havent seen any cross-vendor wireless solution using CAPWAP 'standard' at all.
let alone working on cisco controllers... (gi
On Thursday, July 25, 2013 12:56:52 PM Leigh Harrison wrote:
> I would also like to see more horsepower in the systems.
> We recently went to implement multicasting in VRF and
> ran into some odd challenges. We have the 3600's set
> up for routing and are about to push 24,000 IPv4 routes.
> I
Hi Lumbis,
Thanks for your response.
Its not all about latency, latency may vary depending on the backbone
utilization irrespective of closest location.
I want in such a way that east locations should prefer the default route
from East HUB with West HUB acting as secondary and west locations sho
13 matches
Mail list logo
