Hi all,
UPDATE:
Turned out the policer was fine. Just a small tweak on the ACL got it to
work. Otherwise grateful for all the help
Richard
On 1/31/2010 6:39 PM, Doug McIntyre wrote:
On Fri, Jan 29, 2010 at 10:42:27AM +0300, Mikisa Richard wrote:
Hi all,
Any ideas why the Policer
Hi all,
Any ideas why the Policer policy below does not work. Intention is for
me to lock down traffic to 3Mbps both ways on interface g3/11.
!!
class-map match-all ROKE-LIMIT
match access-group name ROKE-SLAP
!
policy-map POLICY-ROKE
class ROKE-LIMIT
police 300 bps 3 byte conform
Dear all,
In trying to troubleshoot VPN traffic on a Cisco ASA 5520, is it possible to
debug the actual traffic in the tunnel. Scenario: Site to site tunnel comes
up but either side cannot reach the remote nodes beyond the firewalls.
Regards,
Richard
___
Hi all,
I have an issue with a 7206VXR which boots into boot mode without any
errors. The registry is 0x2102 and therefore not the issue, any ideas
what might be wrong.
Richard
___
cisco-nsp mailing list cisco-nsp@puck.nether.net
https://puck.nether.
Hi all,
Scenario below. I have two ASA5520 in my network. Static mapping for
nodes in LAN A work fine however mappings in LAN B don't. I am making
the mapping on ASA1. Any ideas as to get mappings for LAN B accessible.
Internet
|
|
|
ASA1 LAN A - (192.168.0.0/16)
|
|
Hi all,
Scenario is the need to create a VPN tunnel to remote site but remote
site requires that the machine (local host) they connect to have a
public IP. So I have setup a static mapping 10.101.25.25 -> 41.202.X.X.
The tunnel comes up but the connection to the 10.101.25.25 fails. Conf
below
Hi all
I have a scenario where I have to dedicate 256K to a particular host out
of my 1M link. What would be the best way to go about it? Should I do
a simple interface rate limit or should I do a policy and police off that ?
Regards
Richard.
___