Hi all
Issue was mismatched MTU. I reduced them down to 2000 after a ping
sweep and its been steady since.
On Thu, Jul 18, 2019 at 3:18 AM Mike
wrote:
>
> On 7/17/19 6:54 AM, Ćukasz Bromirski wrote:
> >> On 9 Jul 2019, at 17:58, Richard Mikisa wrote:
> >>
> >&g
Hi All,
I have setup unicast OTV between two DCs. Site A uses a Nexus 7010
with a dedicated OTV VDC for the implementation. Site A uses an ASR
1000x. OTV works fine and all the MAC addresses of devices in the
extended Vlan are learnt by the switches in both DCs.
I can ping devices at site B from
Hi All,
I am running OSPF across a point to point link between a Nexus 7000
and an ASR1000x.
The OSPF works fine but every couple of hours, it breaks and neighbor
state goes into EXCHANGE and remains there for another 40 minutes or
so. It then goes into full, OSPF comes up and all is well for
Hi all,
I am looking for advice on the best IOS to run on my Catalyst 4503. I
am going to use it as a PE on a still small MPLS network.
cisco WS-C4503 (MPC8245) processor (revision 4) with 524288K bytes of memory.
Processor board ID FOX112813TS
MPC8245 CPU at 400Mhz, Supervisor V
Last reset from
Hi all,
I have a scenario where I have two upstreams ASN5511 and ASN36997.
Both do send me a default route and I choose ASN5511 as the best path.
All my outbound traffic is via ASN5511 and the return is distributed
between the two. What I want however is to use an advertise map so I
ONLY
on egress...
Hope this helps.
Thanks
On 15 September 2010 09:08, Richard Mikisa rmik...@gmail.com wrote:
Hi all,
I have a scenario where I have two upstreams ASN5511 and ASN36997.
Both do send me a default route and I choose ASN5511 as the best path.
All my outbound traffic is via
Yes it is ..
On Mon, Aug 17, 2009 at 3:22 PM, Alex Balashovabalas...@evaristesys.com wrote:
The config-register is not really 0x2102?
Hi all,
I have an issue with a 7206VXR which boots into boot mode without any
errors. The registry is 0x2102 and therefore not the issue, any ideas
what
There was no upgrade at all. Box was working fine, then a schedules
downtime to sort the power and when it next boots up, it boots into
boot mode.
On Mon, Aug 17, 2009 at 3:30 PM, Matlock, Kenneth Lmatlo...@exempla.org wrote:
If I had to guess, you probably upgraded the IOS code, and didn't