On Jan 27, 2011, at 7:20 PM, "Mike"
wrote:
>
> I was doing some troubleshooting on my 2950g switch. The 'management
> interface', is vlan1, and had an ip address and so forth in it I could reach.
> Apparently, a stupid move was to go into config mode and type the following
>
> interface vl
Try getting someone to power cycle the switch. I'm presuming that you have
written your previous config to flash.
Mark
On 28-Jan-2011, at 9:15 AM, Mike wrote:
>
> I was doing some troubleshooting on my 2950g switch. The 'management
> interface', is vlan1, and had an ip address and so forth
I was doing some troubleshooting on my 2950g switch. The 'management
interface', is vlan1, and had an ip address and so forth in it I could
reach. Apparently, a stupid move was to go into config mode and type the
following
interface vlan 300
At that point, my telnet management session