Hi, ALL,
I have some problems about the NAND flash boot the UBoot, could anyone give
me some advice about it? I make the UBL from the TI, and I conig the
u-boot-1.1.3 source code for the NAND flash, and then I write them to the
NAND flash by CCS, but when I set the btsel[1..0]="00" and set the EM_W
Yes. You can start off in the following manner:
1. TVP is BT656 and interlaced format.
2. CMOS is Progressive and RGB format.
You can add an another device with settings ported from the TVP and the CMOS
so as to arrrive at the BT656 Progressive configuration!!!
Cheers!!!
Sundar
On Fri, Dec 26, 2
BT656 by definition is NTSC/PAL resolution. Are you expecting the full
sensor resolution? If so the only way to do that is to capture in bayer
format and convert.
Steve
Goung wrote:
> Hi, Sundar
> Thanks your reply quickly.
> The MT9M131 is configured to 8-bit bt.656 mode output to ccdc of VP