but the uboot is layout on 0x0-0xa.
On 31 January 2010 22:39, Herbert Miao wrote:
> > > In any case I would assume that after 0x6 (i.e. 384k) no data
> would
> > > be present, and by erasing it nothing would happen. But By erasing
> it
> > > u-boot stops working.
> > >
> > > The comm
> > In any case I would assume that after 0x6 (i.e. 384k) no data would
> > be present, and by erasing it nothing would happen. But By erasing it
> > u-boot stops working.
> >
> > The commands I give are:
> >
> > nand erase 0x0006 0x0040
> > nand write 0x8070 0x0006 0x004000
Hello everyone I am using the FLASH utility to burn the ubl.bin and u-boot.bin
to the NAND flash I am able to burn them sucessfully but when i boot the board
sometimes i get the eth PHY detected and sometimes when i boot The ETH PHY not
gets detected anyone knows what this issue can b.
Have use
Hi Philby,
On Wed, Jan 27, 2010 at 05:11:33, Kevin Hilman wrote:
> From: Philby John
>
> Come out of i2c time out condition by following the
> bus recovery procedure outlined in the i2c protocol v3 spec.
> The kernel must be robust enough to gracefully recover
> from i2c bus failure without havin
Hi Philby,
On Tue, Jan 12, 2010 at 16:47:11, Philby John wrote:
> >From cb3347e45449ff16a332aa164eae24ef6a2432e6 Mon Sep 17 00:00:00 2001
> From: Philby John
> Date: Mon, 11 Jan 2010 15:53:31 +0530
> Subject: [PATCH 1/2] Add SDA and SCL pin numbers to i2c platform data
>
> Patch adds SDA and SCL
