I was wondering if any resolution to this problem was ever found? I am
seeing exactly the same message. The drive works with PIO, but not with
IDE.
Regards,
Andrew
On Fri, 2007-01-05 at 16:02 +0800, gao yuechao wrote:
I encountered the following error when I use hard disk in DMA mode:
Please check your hardware design, especially your pcb layout:
1. Check whether your PCB layout follows IDE design rules;
2. use proper resistors.
Regards
Gao
(www.ruiva.com.cn)
2008/6/11 Andrew Armstrong [EMAIL PROTECTED]:
I was wondering if any resolution to this problem was ever found? I am
Hi,
We figured this out, we had enabled the pinmux so we could use UART0,
however this kills the DMA!
Its just as well we no longer wish to use this serial port (never really
got it working) so we just set up the pinmux to exclude it.
Pretty annoying!
Regards,
Andrew
On Wed, 2008-06-11 at
... and by UART0 I meant UART1!
Hi,
We figured this out, we had enabled the pinmux so we could use UART0,
however this kills the DMA!
Its just as well we no longer wish to use this serial port (never
really
got it working) so we just set up the pinmux to exclude it.
Pretty
I encountered the following error when I use hard disk in DMA mode:
hda: dma_timer_expiry: dma status == 0x20
hda: DMA timeout retry
hda: timeout waiting for DMA
hda: status timeout: status=0xd0 { Busy }
ide: failed opcode was: unknown
hda: drive not ready for command
ide0: reset: success
hda:
