Problem solved.
You have to set CONFIG_MAC_PARTITION=y.
I was quite stupid not to notice this wasn't set. Especially since it says
to use this if your hard drive was partitionned by a Macintosh.
Hope this will give a definitive answer to that problem.
Sam
--
Alcohol: The cause of, and solution
'ello,
On Sun, 2004-09-05 at 06:41, Sam Zoghaib wrote:
Problem solved.
You have to set CONFIG_MAC_PARTITION=y.
Very strange -- at first it /didn't/ work but then I fiddled around a
bit, did a make-kpkg clean and it appears to be working now!
Thanks very much! :-)
bye just now,
--
Matthew
Hi,
Sam Zoghaib writes:
I have just bought a Powerbook 15 1.33GHz. I installed Sarge on
it, then upgraded to Sid. The kernel installed by the installer is
2.6.7. However, I have not been able to run a 2.6.8 kernel. I've
had a few different problems.
[...]
Note that this running kernel
Ok, I have tried to build a new kernel that uses initrd (but keeping ide
support built-in). The kernel boots, goes up to USB detection, and then
freezes instead of panicking as it did without initrd.
Any idea ?
Sam
--
All ITS machines now have hardware for a new machine instruction --
BFM Be
On Thu, Sep 02, 2004 at 04:41:28AM +0200, Sam Zoghaib wrote:
I have just bought a Powerbook 15 1.33GHz. I installed Sarge on it, then
upgraded to Sid. The kernel installed by the installer is 2.6.7.
However, I have not been able to run a 2.6.8 kernel.
I have also tried kernel-source-2.4.27 and
'ello,
On Thu, 2004-09-02 at 03:41, Sam Zoghaib wrote:
Note that this running kernel uses initrd. I don't want to use it for my own
kernel, so of course ide support was built-in.
I have just posted (sorry!) about a very similar problem on my
PowerBook5,4 -- it looks like we're using the same
On Thu, Sep 02, 2004 at 06:05:34PM +0100, Matthew T. Atkinson wrote:
Here is what my .config says:
[snip .config]
I believe as far as that section is conerned, you have far more drivers than
needed (some reported they had their drive working with only the PMAC_*
options and PCI IDE and DMA).
Hi,
I have just bought a Powerbook 15 1.33GHz. I installed Sarge on it, then
upgraded to Sid. The kernel installed by the installer is 2.6.7.
However, I have not been able to run a 2.6.8 kernel. I've had a few different
problems.
If CONFIG_HIGHMEM=y and CONFIG_PREEMPT=y the kernel freezes with a
8 matches
Mail list logo