There is no message from target 3 at all - just the standard message from target
4. It is as if it never sees target 3.
--
Dr. Harry Edmon E-MAIL: [EMAIL PROTECTED]
(206) 543-0547 FAX:(206) 543-0308
Dept of Atmospheric Sciences
University of Washington, Box 3
> I have a system with a Cycle 5 board (Sparc 5 clone) that has two SCSI disks -
> targets 3 & 4 with slink installed on both disks. When I boot kernel 2.0.35,
> all works fine. But when I install the 2.2.1 kernel on my main disk (target
> 3)
> and then boot, the boot goes fine until where it is
I have a system with a Cycle 5 board (Sparc 5 clone) that has two SCSI disks -
targets 3 & 4 with slink installed on both disks. When I boot kernel 2.0.35,
all works fine. But when I install the 2.2.1 kernel on my main disk (target 3)
and then boot, the boot goes fine until where it is scanning t
At 18:01 -0400 1999-05-10, Ben Collins wrote:
Just a note, you can skip the entire portion dealing with the binutils
if you install the binutils-multiarch package, which can handle objects
from any of binutils supported architecures. This means you only need
to build the cross-compiler itself.
hello,
I try to install debian 2.1 from cdrom on a sparc2.
I got the following message :
Detected scsi CD-ROM sr0 at scsi0, channel 0, id 6, lun 0
esp0: disconnect, resetting bus
esp0: resetting bus...
esp0: SCSI bus reset interrupt
esp0: SCSI bus reset interrupt
esp0: disconnect, resetting bus
e
I've updated http://www.debian.org/ports/sparc/>. My changes
(WML) might take a few days to push out into the web mirrors.
Still to do is to finish filling in the porting notes and instructions
(once I figure those out). More significantly, the slink errata page
is yet to be done.
Jules, I hop
The email interface is setup for the wanna-build database. If you would
like to interact with builds, please email me a username and your pgp
id of choice (must be in the debian-keyring).
--
--- - - --- - - - ---
Ben Collins <[EMAIL PROTECTED]>
7 matches
Mail list logo