Hello all, Just a heads up- I will be merging a pull request which moves some BSP settings from `bsp.h` to `syscfg.yml` (https://github.com/apache/mynewt-core/pull/499). If your BSP uses non-default values for these settings, you'll need to add overrides to your BSP's `syscfg.yml` file.
The new settings are below: NFFS_NUM_AREAS: description: > Number of areas to allocate in the NFFS disk. A smaller number is used if the flash hardware cannot support this value. value: 8 CONFIG_FCB_NUM_AREAS: description: > Number of areas to allocate in the config FCB. A smaller number is used if the flash hardware cannot support this value. value: 8 BOOT_SERIAL_DETECT_PIN: description: > Start the serial boot loader if this pin is asserted at boot time. value: restrictions: - '$notnull' BOOT_SERIAL_DETECT_PIN_CFG: description: > GPIO configuration for the serial boot loader detect pin. value: 'HAL_GPIO_PULL_UP' BOOT_SERIAL_DETECT_PIN_VAL: description: > The value the detect pin must be set to for the serial boot loader to start. value: 0 BOOT_SERIAL_REPORT_PIN: description: > The GPIO to toggle while the serial boot loader is running. Set to -1 to disable reporting. value: 'LED_BLINK_PIN' BOOT_SERIAL_REPORT_FREQ: description: > The toggle rate, in Hz, of the serial boot loader report pin. value: 4 Thanks, Chris