ut down for tuning. Do these go away if you set
> the tx_gain to zero just before and to its original value just after tuning?
>
> Best regards,
>
> Marcus
>
> On 03/09/2017 08:21 PM, Michael Skaggs wrote:
>
> Hi all,
>
> We are working with an E312 platform and
ance over a 50Ω resistor.
>
> Best regards,
>
> Marcus
>
> On 12/23/2016 10:50 PM, Marcus D. Leech wrote:
>
> On 12/23/2016 01:45 PM, Michael Skaggs wrote:
>
> 1 MHz signal with a 6.25MSps rate. We just attempted a signal at 5MHz and
> measured it at 114mV RMS, a 10MHz
, 2016 at 10:44 AM, Marcus D. Leech <mle...@ripnet.com> wrote:
> On 12/23/2016 10:26 AM, Michael Skaggs wrote:
>
> Hi all,
>
> We're currently working with a BasicTX daughterboard attached to a N210
> USRP. We are using both outputs of the BasicTX in quadrature (I on one
&
Hi all,
We're currently working with a BasicTX daughterboard attached to a N210
USRP. We are using both outputs of the BasicTX in quadrature (I on one
channel, Q on the other). The problem we are running into is that the
output power of the BasicTX board seems very low. Looking at it on an
uch much worse than what to devices that should have the same
> device time should exhibit. So:
> How are you setting the device time?
>
> Best regards,
> Marcus
>
>
> On 04/21/2016 08:59 PM, Michael Skaggs wrote:
>
> Aha! You were correct. I was parsing the header incorrectly
, especially considering that the are synchronized to the same PPS,
and I think the time is with reference to the pulse.
Michael
Michael Skaggs
M.S. - Computer Engineering
LinkedIn <https://www.linkedin.com/in/MichaelDSkaggs> | Resume
<http://goo.gl/NBEs2y> | Research C
I'm trying to time/sample synchronize RF recordings with two B200minis. I
am using the detached Metadata File Sink in GRC. Both recordings are at
30MSps and both B200mini boards are synchronized to the same 1PPS signal.
My issue is this, when I extract the data from the Metadata header file,
the
Hi all,
I'm doing a simple RF recording with a B200mini synchronized to an accurate
GPS 1PPS. I'm attempting to determine which samples(most importantly the
first one) fall on a 1PPS pulse. I'm using the File Meta Sink block in GRC
to try and extract information from the recording. When I read
Hello all,
After sorting out my power issues with the B200mini (it required a dual USB
to 3.0 mini cable, due to browning out the single USB 3.0 connection), I'm
now trying to connect my B200mini to a Raspberry Pi 2.
I was excited when I found that Raspbian has a gnuradio and gnuradio-dev
