Hello,
I've seen a few threads touching on real time flow graph switching but I
haven't been able to implement a solution to my particular problem.
Setup:
2 USRPs + 4 RFX900 boards + 1 RF Source at 864MHz (European SRD band)
Task:
I want to run three specific programs one after another in
Hello,
I noticed that the guys at Open PCD have built a RFID sniffer for use with
GNU Radio
http://www.openpcd.org/rfiddump.0.html
I was wondering if there much third party hardware out there?
Tomas O'Maille
--
View this message in context:
Matt,
Thanks again.
Tomas
--
View this message in context:
http://www.nabble.com/RFX900-Transmit-Power-tp15270526p15306470.html
Sent from the GnuRadio mailing list archive at Nabble.com.
___
Discuss-gnuradio mailing list
Discuss-gnuradio@gnu.org
Thanks Matt,
Your board was already configured properly and you don't need to do any
of this.
Glad I didn't stumble in with a soldering iron.
Tomas
--
View this message in context:
http://www.nabble.com/RFX900-and-Clocking-Notes-tp15202177p15264312.html
Sent from the GnuRadio mailing list
Hello again,
I have another question regarding the RFX900 daughterboard.
I am trying to get a sense of the power transmitted by the RFX900 board
in order to avoid breaching European communication regulations.
Ideally a figure for the equivalent isotropically radiated power (EIRP)
would be
Hello,
I am reading the Clocking Notes in order to set up a coherent 2 antenna
system.
My setup is a USRP Rev 4.5 and two RFX900 daughterboards dated 3-10-2006
Step1: I want to disable the RFX900 clocks so I need to
Move R64 to R84, Move R142 to R153
which looks straight forward.
Step 2:
Hello,
I have been trying to understand the tx and rx data paths through the AD9862
and the FPGA (standard configuration).
RX side:
- The two ADCs of the AD9862 push data onto two 12 bit buses
- After the FPGA MUX the 16 bit I/Q signals pass into the assigned DDC
- Are four extra bits
