You'll want the secondary IP address network on the WAN side of your Endian to
be different than the IP range on your Green network. You're confusing the
route process with both being in the same network.
Mike K.
From: Chris [mailto:[EMAIL PROTECTED]
Sent: Mo
Hi,
I have an ADSL modem in front of the RED NIC of my efw, connected using
PPPoE.
So the ppp0 have 2 ip, the public internet ip address, and the 10.0.0.1
address.
How can I access the modem, from the GREEN side, which is supposed to
be on 10.0.0.138 ? Should I add a specific route to it ?
Tha
Hi.
How about setting up VPN to do that?
Met vriendelijke groet / With kind regards
Marc Fellman
Send with my iPhone.
Verstuurd met mijn iPhone.
Op 10 nov 2008 om 17:08 heeft "Julio Cesar" <[EMAIL PROTECTED]> het
volgende geschreven:\
> Hello,
>
> I need to set the Endian Community 2.2 RC3
Very Thanks to Steven Sher and J Revell.
Bye,
Julio
2008/11/10 Steven Sher <[EMAIL PROTECTED]>
> Open port 10443 under external access, that will give you remote access
> to the box.
>
>
>
> You can also enable ssh under system, and open port 22 on external access,
> if you need ssh access.
>
Julio Cesar wrote:
>
> I need to set the Endian *Community 2.2 RC3* so i can manage it remotely,
> outside of the office. What is to be done?
>
You can add rules for port 10443 (web admin) and 22 (SSH). However for more
secure access, I would recommend setting up OpenVPN, and using an OpenV
Open port 10443 under external access, that will give you remote access to the
box.
You can also enable ssh under system, and open port 22 on external access, if
you need ssh access.
Lastly if you don’t have a static IP configure dynamic DNS
Hope this helps
Steve
From: Julio Cesa
Hello
I configure 2 Endian Firewall with VPN IPSec Net to Net, everything was
fine, I can see mi remote network and then too.
I want to restrict a single server can see only 1 server, HOST to HOST, how
can I do it?
-
This SF.Ne
Hello,
I need to set the Endian *Community 2.2 RC3* so i can manage it remotely,
outside of the office. What is to be done?
Thanks,
Julio
-
This SF.Net email is sponsored by the Moblin Your Move Developer's challenge
Build
Thx man! I will give it a go :)
compdoc wrote:
>
> Log onto the console, and type these commands:
>
> nano /etc/clamav/clamd.conf.tmpl
>
> Then down arrow key to the line that says:
>
> DetectPUA yes
>
> Change it to:
>
> #DetectPUA yes
>
> Then press control x, type y where it asks to s
