Ken,
I have not experienced the difficulty
with my P3 that you encountered,
but the fact that both the P3 front
panel display and the external SVGA
display shut down indicates a problem
with data not being provided to either
display driver system OR there is a
thermal problem with one of the
onboa
I am looking to buy an already built Elecraft K1 Noise Blanker KNB1.
The pulse noise from the nearby power lines makes the Elecraft K1
not very usable at this location.
Ken
N4SO
E-mail redscarlette7...@gmail.com
__
Elecraft mailing list
I'm selling my KX2 serial #02516. It is a base unit. I have used it
for POTAs and in the RV.
I did add the following
Side KX End Panels
Side KX Cover
QRP Works SideKar with keyboard
KX2 Owner's Manual
The Nifty Mini-Manual
The Elecraft KX2 by Fred Cady
Asking $1000 - inc
Used KPA-1500's are not that hard to come by, there are two for sale right
now on QTH.com
https://swap.qth.com/search-results.php?keywords=kpa+1500&fieldtosearch=titl
eordesc
John KK9A
Larry Boekeloo KN8N wrote:
I'm looking for a good used KPA-1500. I know they are hard to come by. I
have a K
Mark,
I am guessing that bias voltage is being supplied from another route or
that MH4 would not work. Some ops place the resistor on the mic
configuration header as opposed to the mic connector itself. That may
explain why it is working in the other rig.
Either way, sounds like you have thi
About 8 hours into CQWW CW, one of my P3's bandscope function stopped
working. I checked the cables. I powered the unit off. When it came on, it
worked for a few seconds. The outboard monitor worked for a few seconds.
Then it stopped working. I did this a few times with the exact same
results. I ne
ConfirmÂ
Sent from the all new AOL app for Android
__
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://w
Everything setup to the point of ‘Fine carrier Balance Adjustment. But no
RF output. The SSBA BAL adjustment worked fine so there must be a low level
SSB signal to be fed back to the Rx. Current jumps from 222mA to 398mA on
activating PTT. No increase with audio input, no S meter indication or
indi
This board is part of a production run they are doing now.
I have one on order. Not sure if they have a larger amount then what was
pre-ordered.
73 Henk PA5KT
Op 26-11-2021 om 17:31 schreef Gary H. Harmon, Jr.:
A good friend's K3 was damaged in a thunderstorm several months ago. After
think
9 matches
Mail list logo